20 Most Recent 2001 Pontiac Montana - Page 8 Questions & Answers

there are many causes of cylinder misfire, the most common being ignition. plugs or wires being faulty can cause misfire. also faulty or plugged injectors, loss of compression such as blown head gasket.

After you change brakes you need to bleed air from the brake lines what you need to do is find the bleeder valve its usually rite beside where the brake line goes in the calipers and looks like a grease fitting get someone to pump the brake pedal 3 or 4 times and hold it while someone else loosens the bleeder valve to drain the air out keep the pedal mashed until you get the bleeder valve tightend back up . Do each wheel until fluid comes out check brake fluid while doing this so it doesnt run out. Hope this helps

Here's a link to your oil pan,doesn't matter how to remove,just putting them back in.

Have your battery load tested at auto parts store. Do it while still in the car. They can also check your alternator at the same time. It sounds like you either have a short that is draining the battery as it sits overnight or as your vehicle runs the battery has enough charge to run but not enough charge to last it UNTILL the next morning.

take direct current to motor should activate reverse polarity should activate, now if it alright the switch or cut wire door harness where it bend

there are 2 upper strut mounts attached to the front of the motor.

Should be above the oil filter or the starter.

If your car is misfiring when driving then it could be your ignition module. I had the same problem and changed all plugs and wires multiple times, also had the coil pack fixed. It ended up being the ignition module. Try changing all plugs and wires then have the ignition module checked.

sounds like 2 problems one the transmission throwin u forward and high rps then cloged converts slow to speed and wont go pass 80 kilometers If you need further help, reach me via phone at https://www.6ya.com/expert/james_9c1b039055413ffa

sounds like a rocker arm adjustment is needed. If not adjustalbe replace rocker arm. Rod knocks do not go away

This is a common problem with Chevy Venture, Olds Silhouette, and  Pontiac Montana. The mechanical wiper drive and parking cam assembly, if it's not broken, needs adjustment. The spring loaded stop arm should engage the vertical tab on the assembly mounting plate when the wiper motor reverses. See pic. 
I will upload the instructions to fix this problem, if there is interest.

Duplicate question

What is the fault code.

Could be engine coolant temperature sensor. Easy fix but that will make your temp guage read wrong and can affect heat output in vehicle.

What is going on any nose or quiet.

Clogged catalytic converters act like plugged exhausts. It will cause loss of power.