2006 Pontiac Montana - Answered Questions & Fixed issues
Tilt steering lever removal
2006 pontiac montana
2004 was the last year for the montana and it was exactly the same as the 2001. In terms of the tilt lever, they were all the same. Just grab it and pull straight out from the column.
You can use a screwdriver to pry if its too hard. Utube has several videos demonstrating the technique.
10/1/2019 6:12:14 PM •
2006 Pontiac...
•
Answered
on Oct 01, 2019
•
242 views
Replace serpentine belt on a 2006 Pontiac Montana 3.5l
I find the best way to replace the belt on any car is to have a piece of paper and draw circles where each pulley would be and draw a yourself a picture where the belt would run up and over or down and under. Never fails for me. Do not take your belt off before you draw yourself a picture.
12/13/2016 1:59:11 PM •
2006 Pontiac...
•
Answered
on Dec 13, 2016
•
1,681 views
06 montana chime wont stop out of park all doors shut tight
Might have a door switch bad is bad or wiring to one of the switches. I would begin by checking if there are any blown fuses. Would then check wiring to each door, along frame inside a rubber boot where door hinges are. If wiring is all good, I'd then move on to removing door panels and disconnecting each door latch harness until the chime goes off. This will indicate the specific switch that is bad. If all are good.
11/6/2016 8:31:51 PM •
2006 Pontiac...
•
Answered
on Nov 06, 2016
•
373 views
Where are the spark plugs for a2006 poinac Montana
Below is a picture of the ignition coil, connected to the coil are spark plug wires, follow those wires from the coil to the end, at the end you will find the spark plug wire connected to the spark plug which is screwed into the cylinder head of the engine, there are 6 spark plugs.
10/14/2016 10:05:38 PM •
2006 Pontiac...
•
Answered
on Oct 14, 2016
•
43 views
Motor light come on
Do you have the owners manual?
Make sure it is a motor not transmission light, also you can have the light checked at most any part store for free.
3/11/2015 9:33:05 PM •
2006 Pontiac...
•
Answered
on Mar 11, 2015
•
50 views
How do i service traction system
You will need to diagnose the code first. The traction control and abs systems are tied together, usually there is a bad wire on the front end. The way the wires are routed for the abs system makes for cut or pinched wires to one of the front hubs causing an open circuit to one of the sensors for the abs system. This causes the traction control system to quit working. Diagnosing the trouble code should tell you where to look
7/29/2014 11:58:11 PM •
2006 Pontiac...
•
Answered
on Jul 29, 2014
•
332 views
02 montana abs pump comes on running 55 with no
the problem is front wheel speed sensor. to check witch side .you have to know voltage of speed sensor at 20kmh steady. ex, left side read 800mv right side read 330mv then the right side is defect for example.
8/4/2013 6:11:36 PM •
2006 Pontiac...
•
Answered
on Aug 04, 2013
•
106 views
Not finding what you are looking for?