20 Most Recent
1988 GMC S-15 - Page 7 Questions & Answers
Removing rear axle seals for
Pull the rear wheels,take off the diff cover,remove the 5/16 pin that holds the big pin,pull the big pin ,push in on the axles,remove the 2 c clips that are on the axles and slide the axles out.If the axle shaft is worn by the bearing,an axle -saver bearing is available. If the axle is ok just pull the seal ,drive the new one in and re-assemble.
Remove truck bed to repair gmc s15
Not to difficult what do you want to do to it repair a side panel or remove the bed completely? all you have to do is take out the center frame bolts out of the rails in the bed disconnect wiring harness at rear where lights plug in on drivers side and if you don't have a bed liner or camper shell then the only other thing is remove the bolts or screws from the fuel tank so the filler hoses stays with the bed. It can then be easily taken off the bed with two or three guys, or you can slide it off from the front to the back, or block it off with 4 1/4 oil barrels, make sure there is no brackets attached to the fender. Hope this is what you were looking for. Any questions let me know, you can buy side pannels if it has the side paller damaged if you have a drill and a welder.
Not finding what you are looking for?