20 Most Recent 1997 Dodge Intrepid - Page 5 Questions & Answers

did u check your relays they might be bad

put an engine flush in first . run the engine on tick over .till oil is hot then drain it. do an oil and filter change may have a build up of carbon in the engine .the flush should deal with that .use 20/40 oil .

Check your mass air flow sensor (maf). It can be cleaned with brake cleaner or MAF cleaner.

automatic?? low fluid or cold fluid..check.. add if low may need a fluid and filter change..

check the plugs and wires vaccume leaks low fuel pressure

I just fixed that vibration problem on my 97 intrepid.I replaced the cv axel which was only 54.00 bucks brand new.No more vibration when excelerating

Do you mean the switch that activates the brake lights, If so, its usually down by the brake pedal ..follow the brake pedal up untill you see where its contacts the plunger switch

probably not as the only thing causing the blockage apart from foreign matter is an incorrect head gasket or a gasket that has been fitted incorrectly that is blocking up the oil hole.

car and engine type? some 3.1 liter gm cars push rods are different lenght for exhaust and intake you might have them in wrong holes

egr valve? Not sure

have u tryed to replace the camshaft sensor i had the same problem with my 97 intrepid today and itworks like a dream now.

need to unplug and ground out purple wire it should go to empty then remove from ground it should go to full if that works it will need a new fuel sending unit

Sometimes dash gets hot and warpes or check cable at trans

There is a switch on the dash that adjust the glowing of the dash lights. This switch maybe turned all the way up and may need to be readjusted,

Have a repair shop start diagnosing yourthoughts of a worn key cylinder or ignition switch