2007 Chevrolet Silverado 2500HD - Answered Questions & Fixed issues
Are the chevy 2500hd any good
edmunds do a good review of cars...
http://www.edmunds.com/chevrolet/silverado2500hd/review.html
"For an intermediate heavy-duty pickup, it's hard to go wrong with the
Silverado 2500HD."
Locked my keys in my 2011 chevy silverado
Align the slim jim with the lock and push it downwards towards the keyhole.When you see the lock start to move, pull the slim jim upward slowly until the door unlocks.
The wait to start light want go out and when the
The code P0674 tells you that something in the glow plug circuit is faulty causing the glow plug on cylinder #4 to fail to heat up. The entire circuit must be checked to locate the fault.
Symptoms With just one glow plug failure other than the check engine light coming on, the symptoms will be minimal since the engine will normally start with one bad plug, under freezing conditions you would be more likely to experience hard starting.
Potential Causes The causes for this DTC may include: Faulty cylinder #4 glow plug Open or shorted glow plug circuit Damaged wiring connector Faulty glow plug control module Diagnostic Steps & Possible Solutions You will need a digital volt ohm meter (DVOM) for the complete test.
Continue through the tests until the problem is confirmed. You will also need a basic OBD code scanner to reset the computer and erase the code. Check the cylinder #4 glow plug by disconnecting the wire connector on the plug. Place the DVOM on ohms and place the red lead on the glow plug terminal and the black lead on a good ground. The range is .5 to 2.0 ohms, if it is out of range replace the glow plug.
Truck goes plum crazy while driving.
I strongly suggest you contact a local dealer, I have never seen this symptom on any GM vehicle. I think you have a loss of battery power for some reason or a faulty ground, where that may be is another story.
Engine power is reduced
get the codes pulled. even if no lights are on it can have codes. i think pepboys and advanced autozone do it free.
How do I remove the cable for the door handle on a 2007 chevy 2500hd?
Remove the door panel. There will be several screws to remove, look for plugs in the door, screws will be behind them. After that lift up on the panel, if it doesn't lift, then insert a screwdriver at the bottom of the panel. It pops of, be prepared to buy some door panel plugs. They break. after that you will see how the cable runs and be able to remove the bad part. Not all cables break.
No power to relay for power seats and right window at fuse box
I had the same issue on m dads 2005 Z71. It wound up being a bolt fell in the track of the seat and skint a wire and grounded out. resulting in a blown fuse and seats and all windows but the driver window quit working. Also check the connectors under the seat, some of them can be seperated just enough to cause a power problem
Engine shut down wile driving wont start
will it turn over after it stalls? if alternator is not charging the battery will go dead while driving, if thats not your problem you need to ck for spark and fuel, a bad fuel pump can cause that problem, runs when cold then loses pressure once its run for a while
What is the code p0087 in my 2007 chevy duramax
SES suction supply vacuum. GM BULLETIN #PIP4526. It's a vacuum hose that is getting hot under load and loosing its rigidity and collapsing. You gm dealer should be able to supply you with and updated hose. Ask them to print out the service bulletin to walk you through the repair.
Put new actuator on still not working
Very common problem. Actuators need to be re-calibrated. Disconnect battery with ac controller off. And reconnect after 5 min. If not your going to need a modis to recalibrate.
Not finding what you are looking for?