2007 Hyundai Santa Fe Limited - Answered Questions & Fixed issues

I had exact problem Santa Fe 2007 2008 lock was stuck in locked position and door would not open from inside or out. All other doors would unlock with auto key remote. Carefully work the inside lock towards the open position as you lock and unlock the door with the remote. As you press unlock try to assist the lock to open. I did this a few times and the lock became free to the open position and all worked perfectly after this.

the motor to move it back and forward may have gone out or the switch died

hi there! i was a master tech for hyundai, common problem to say the least, many times i had this. please feel free to contact myself and i can take you step by step to resolve this.

many thanks

Dominic Hill

crankshaft position sensor faulty...works until it gets hot then shuts down entire engine until it cools. replace the sensor.

how to change the fuel filter on 2007 hyundai santa fe

https://www.wikihow.com/Bleed-a-Slave-Cylinder

It is most likely it is the hood switch. A vibration in the earth would vibrate the vehicle just a bit to make the hood pin not make enough contact. The pin itself would make a indentation on the rubber bump on the hood. This makes the pin not press down enough to make contact and thus made it go off.



One other possibility besides the hood pin problem is when the siren assemblygoes bad. This problem surfaces when driving down the road or just sitting in front of your house. It's an internal short in the siren assembly.

On this website you find fuse box diagram and description for Hyundai Santa Fe Hyundai Santa Fe 2007 2009 fuse box diagram Auto Genius

to much gas fumes can make you ill thats why you fill or transfer gas in a well vented area --will need to look for what vent ,line or component is causing the fumes

1st ck your brake lts, check to see if u have voltage & ground at the switch (under the brake pedal) If all is well replace the switch, depending on the yr of the car, disconnect the battery ground for 10 sec to erase the codes.

Depends on the vehicle. Type in your year make and model on google and the location and it will pop right up, then can go to youtube for replacement videos.

check for a blown throttle fuse

2007 2009 HYUNDAI SANTA FE REPAIR MANUAL for the best solution of your problem visit this site

Was noise there prior to brake replacement? If so, possible wheel bearing noise. Noise should get louder the faster the wheel rotates with a bearing problem.

http://www.carcomplaints.com/Hyundai/Santa_Fe/2007/recalls/

Should have an automatic tensioner

it sounds to mee like the brake power booster or abs is acting up.if you dont feel safe driving it use it as a trade in for another vehicle that you feel more comfortable with

Lots of possibilities. Clean the egr valve and the mass air flow sensor first. New air filter. If over 75000 miles , new spark plugs. Spray the throttle body throat with cleaner with motor running. Use good injection cleaner like Bg or have it done professionally..

POSSIBLE WRONG OR DEFECTIVE SENSOR

If your referring to a ck engine light you may have gotten a vacuum leak or air filter no sitting correctly.Check that first,next, Reset the comp by disconnecting neg bat conn for 10 seconds,reconnect, drive high & low speeds for a few miles to see if light returns. If it does get it scanned by a shop for a diagnostic.