20 Most Recent
2011 Lincoln MKX - Page 3 Questions & Answers
My husband and I purchased
Hello, Call Lincoln Customer Service to report this problem. Be glad that none of the mice died inside your duct-work. It would be hard to imagine the mice lived inside your vehicle before you drove home. But as a dispute issue, you did not order a factory mouse-equipped car. You do not know where the mice came in, but you also do not know when they arrived either.
It is becoming more common to use natural materials like SOY-based foam for the seats and some of the wiring and insulation are derivatives of this and other organic materials. To me this is like putting food out for the varmits.
Our problem on our new 1988 Lincoln Mark 7 Bill Blass Edition was also caused by rodents of another type. Our A/C stopped working. When the mechanics opened the ductwork they found about 3 pounds of Black Walnuts that had been dropped into a hole in the air valance under the windshield. We had wondered what the squirrels were doing running under the car all the time. They picked an expensive stash for their winter food. Our Dealer did not charge us a dime for all the work involved in opening the dash. They even bagged the Walnuts and left them for us.
Twenty-two years later we are still purchasing Lincolns from their Dealership. I would call the main Lincoln Customer Service and since they can not say when the mice arrived, they could at least split the bill with you. Put some traps inside your garage too!
The right rear door of
hi.
anthing this new should be taken back to the dealer and let them fix it under warranty.
do not attempt to repair it yourself as this would certainly invalidate any warranty on any parts you repair yourself.
it probably only needs adjusting, but it must be done by the dealer to preserve the warranty
My 2012 Lincoln MKX only blows cold air from the drivers vents and only blows hot air out the passenger vents regardless if I have the ac on or heat on. Please help.
bad blend or mode damper door motor actuators. is cause (maybe)
we know how to move them by hand motors off (actuators)
hot all the time is blend unless AC compressor is dead.
yes blend doors can jam fully to hot, sure can.,
It needs service, there are other causes.
most of the tests you can not do. or easy.
there are 2 systems here.
- the blower distributor system. (dampers 3 or more0
- or
- the AC R134 loop dead or weak.
what I do is make sure the compressor runs
and if does,
move the blend door by hand (my jeep has built in self test of this)
and by hand I put the damper to evap core only mode and if no cold air now, the loop is bad and I stop here, lots more tests from hear.
or he AC condensate drain is clogged even covering up deeply evap core . blocking is air flow., and super common this and a simple fix.
Mouse made it's home inside
I blocked the front air intake with steel wire mesh. They still were getting in. A few days later I pulled off the bumber Ann noticed all four rear vents were chewed open. I added the steel mesh on the rear vents and the problem is solved.
Electrical problems
tack battery cable loose from battery for 5 minits then put battery cable back on battery and restart tye the trunk shut with a rope to take it to mechanic friend to check lock
The inside lights will not shut off
There is a control on some Dome lights which override the door sensors. The headlamp control on some dashes will turn on the interior lights if they are turned to one extreme direction.
Genie garage door op
There is a set button on garage door opener look at manual that is in the garage hanging. to make car and door work together you will need both manuals
Not finding what you are looking for?
