Sounds like the carb could use a cleaning and setting by a professional...install a new plug and a new air filter.. AFTER the professional carb cleaning and setting.,,do this and repost
SOURCE: klx 110 2006 stalls when choke is pushed in
i'd say the carb is gummed up especially the pilot jet (#16158) in this pic of the USA carb. may have to remove the carb & bowl and then remove the pilot jet (w/ flat head screw driver) and clean out the tiny holes.
http://partsfinder.onlinemicrofiche.com/atlanticcycleandpower/Kawasaki_OEM/KawasakiDB.asp?Type=18&A=39&B=17&Action=O
-OR-
the carb slide is installed backwards (turned 180 degrees). its #16025 in the pic. i've done this before on my daughter's XR70 and Z50. you'll know if its this when you move the choke lever, RPMs increase and decrease.
hope this worked for you and was fast enough.
SOURCE: 2005 yamaha yzf 250-unstable idle
I had the same problem, Turns out that my shims were finished, replace the chims and check clearences.
SOURCE: yamaha big bear no spark
I'm not familiar with all quads and all the kill switch locations. Does it have a tip-over kill switch? Is it working? Is the quad in neutral? Is the neutral light on? Many engines will not spark if the neutral light is not on. Are the headlights off when starting?
How good is your battery? A low battery can kill spark. Test for spark by grounding the threads of the plug against the cylinder. Have a friend kick the bike while you watch for spark. Assuming no spark, then check all the kill switches with an Ohmmeter to be sure each switch is working properly. Sometimes a switch goes bad. Try disconnecting all kill switches then check spark.
Check the wiring harness, even under the gas tank and seat. Are all the connectors clean and with a tight connection? Any abraded wires? Check the ignition switch also. The switch can go bad as well. Are the flywheel coils good > is the battery getting a charge?
Still no spark? If CDI then get it checked.
If points then file or replace them along with a new condensor and reset the gap then time the engine. >> I hope this helps.
Please rate this answer. Thanks trsrhntr!
SOURCE: Will not run without choke
have you checked for vaccuum leaks at the intake manifold? you can check by pouring water over the gasket area when/ if you get it running!
3,257 views
Usually answered in minutes!
×