20 Most Recent kawasaki 2004 Bayou 300 4x4 - Page 2 Questions & Answers

Sounds like a vacuum leak or something is binding open. Spray ether or brake klean around all connections to see if there are any leaks and/or open it up again and check for sticking parts or misplaced springs

Make sure the needle/seat spring is still there. also make sure your fuel filter is clean enough to keep up to your carb's new thirst

The first things I would check are seized brakes and then transmission condition/fluids. The auto has 2 clutches I believe. Make sure everything is full on fluids

whats the question?

very good I need help that they gave a kawasaki bayou of the 94 4x2 300 and I need to know where the numeration or vin of the chassis and engine have if they can help me they are grateful

Depends on the size of the motor, the size of the crankshaft end, the number of magnets and their arrangement, etc..etc,, check ALL these before you purchase one..

Hey Dave, thought I answered this already,,,??? Classic "brass kit" symptom! >>> You need a "brass kit".. this is the needle jet and the jet needle in the center of the carb. The jet needle is the thin needle that hangs down from the center of the slide... The needle jet is the "hole" that the jet needle slides into...Remove the carb, take the bowl off, remove the main jet, the needle jet holder should be able to be gently tapped out, the needle jet is a short brasspiece,, it comes out through the hole where the slide goes,,, reinstall the NEW needle jet, needle jet holder...(it may have a groove in it for correct location). once its seated, you can reinstall the main jet..NOW >> to install a new jet needle,,, remove the slide from the carb.. remove the spring and seat from the slide that holds the needle jet in place.. NOTE which groove the clip is in on the old needle.... (should be the middle one). re install the new needle, reinstall everything else and your atv WILL run fine for a long time..This is a common problem on ATV's.. you need part #'s 1990 Kawasaki BAYOU 300 4X4 KLF300 C2 Carburetor http://www.kawasakipartshouse.com/oemparts/p/kawasaki/16009-1503/needle-jet-n36w http://www.kawasakipartshouse.com/oemparts/p/kawasaki/16017-1270/jet-needle-6

It's burning oil. Most likely from worn piston rings.

Chapperalmotorsports.com has free diagrams for everything outdoors i use their service often they will help you with the instructions too. Hope this is useful for you i have always had great luck with them they go out of their way to answer any question &i their prices on parts are great

May be water in the gas or your spark plug may be misfiring and also the air filter may need replacement or cleaned out..Hope this helps!