Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"change filters, and clean the inside of pipes from tank to injectors, use a thin peice of..."
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"580 Case SK Backhoe has got so it will only start with starting fluid and run if I keep..."
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"something wedged inbetween teeth on gear. might have to replace the gear... this means..."
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"I have a 1990 685 Case IH. 4X4 tractor. It has high, low, and reverse on 1 shifter, and it..."
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"tighten/shorten the cable that is attached to the back of the pedal"
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"clutch adjustment for Interntional Tractor 986"
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"backend by the linkage someware, sory but dont know what oil to use"
Anonymous posted an answer for this The Times Case Corporation Tractors International Harvestor:
"where do fill up hydraulic fluid on a 1490 case tractor what fluid do i use. there is a..."
Anonymous posted an answer for this Exceed-RC Exceed RC 1/10 Electric Radio Remote Control RC Drift Racing Car, Complete:
"faulity wiring in the plug?"
Anonymous posted an answer for this Exceed-RC Exceed RC 1/10 Electric Radio Remote Control RC Drift Racing Car, Complete:
"My drift car doesnt seem to charge what could cause this?"
Anonymous posted an answer for this RTO Massey-Ferguson Tractor TE20, TO20, TO30, ITFE2:
"hello , my reverse gear is worn on my mf35 , my question is if i remove the shaft to..."
Anonymous posted an answer for this RTO Massey-Ferguson Tractor TE20, TO20, TO30, ITFE2:
"no shouldnt do un-less the bearings are worn badly, which is very hard to do."