Warranty service technician (most brands)
Anonymous posted an answer for this Panasonic PT-53TW53 53" Rear Projection HDTV-Ready Television:
"I take a flat tip screwdriver and place it under one side of the plug tab. lift it up and..."
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"you can try removing the 3wire plug that runs to the ATSC tuner (1orange wire 2 white..."
Anonymous posted an answer for this JVC AV-56WP74 56" Rear Projection HDTV-Ready Television:
"If you are good at soldering and desoldering then you can do it. I get the 150's from..."
Anonymous posted an answer for this Building Materials:
"Thanks guys, I'll just keep my eyes open."
Anonymous posted an answer for this Building Materials:
"Thanks guys, I'll just keep my eyes open."
Anonymous posted an answer for this Panasonic PT-61LCX65 61" Rear Projection HDTV:
"The procedure information comes with the part, just follow the included directions exactly..."
Anonymous posted an answer for this Panasonic TC-32LX20 32 in. HD-Ready LCD Television:
"It sounds like the red cable on your component input is bad, one way to check this is..."
Anonymous posted an answer for this Panasonic PT-52LCX65 44" HDTV:
"Go into the audio menu of the tv and turn the internal speakers to on. There will be an..."
Anonymous posted an answer for this Panasonic PT-61LCX65 61" Rear Projection HDTV:
"Per panasonic's autorized tech website it is corrupt EEPROM data. It is corrected using..."
Anonymous posted an answer for this Panasonic PT-61LCX65 61" Rear Projection HDTV:
"Per panasonic's autorized tech website it is corrupt EEPROM data. It is corrected using..."
Anonymous posted an answer for this Panasonic PT-61LCX65 61" Rear Projection HDTV:
"Your problem more than likely lies in your lamp. The whirring noise you hear is the..."
Anonymous posted an answer for this Panasonic PT-47WX53 47" Rear Projection HDTV:
"You are on the right track. The problem is actually with the green convergence IC that..."
Anonymous posted an answer for this Panasonic PT-45LC12 45" Rear Projection HDTV-Ready Television:
"That is the blink code for the lamp ballast. Here is the more complicated explanation from..."
Anonymous posted an answer for this Panasonic PT-53TW53 53" Rear Projection HDTV-Ready Television:
"It is a 2.2K ohm resistor, here is the info out of the service manual. R7031 ERJ6GEYJ222V..."
Anonymous posted an answer for this Panasonic PT-53TW53 53" Rear Projection HDTV-Ready Television:
"Try vance baldwin, they have good prices and will sell to non service shops. Hope this..."
Anonymous posted an answer for this Mitsubishi VS-60603 60" Rear Projection Television:
"It may be fluid from the picture tubes. They have a silicon based fluid inside the lens..."
Anonymous posted an answer for this JVC AV-48WP30 48" Rear Projection Television:
"1. if the 1.5 ohm resistor was open, then you may have fried your new convergence ic's...."
Anonymous posted an answer for this JVC AV-48WP30 48" Rear Projection Television:
"Your convergence IC's are bad and maybe a few of the supply resistors. Not an expensive..."
Anonymous posted an answer for this JVC AV-48WP30 48" Rear Projection Television:
"The convergence board part# is SSB-5051A-M2 and is available from vance baldwin for about..."
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"It may be lamp, Look at the lamp and see if there is any discoloration inside, but do not..."
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"coaxial cable"
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"On this model there were two power boards used, i would look at the srp# on the power..."
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"If the fan doesn't start then this model will shut down and the power light and lamp light..."
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"This is the lamp error code. The lamp part# for your unit is TS-CL110U. Hope this Helps."
Anonymous posted an answer for this JVC HD-52G886 52" Rear Projection HDTV:
"This is the shutdown code for the lamp ballast. I would have a technician verify ballast..."
Anonymous posted an answer for this JVC AV-56WP74 56" Rear Projection HDTV-Ready Television:
"This may help, the part # is 56sc-001a-m2. Unfortunantly you cannot order just the front..."
Anonymous posted an answer for this JVC AV-56WP74 56" Rear Projection HDTV-Ready Television:
"This is caused by failing convergence ic's. They take the image from the three picture..."
Anonymous posted an answer for this JVC AV-56WP74 56" Rear Projection HDTV-Ready Television:
"You do have to take them off of the circuit board but.... unless you are good at soldering..."
Anonymous posted an answer for this Samsung HP-R4252 42 in. Plasma HDTV:
"This is probably caused by the small signal board. It controls and decodes the picture..."
Anonymous posted an answer for this Samsung HP-R4252 42 in. Plasma HDTV:
"Since you smell it above one side of the panel I will guess the right side (from the..."
Anonymous posted an answer for this Samsung LN-S4051D 40 in. LCD Television:
"This sounds like a power supply issue and since your tv is under warranty it should be..."