Anonymous posted an answer for this GMC Cars & Trucks:
"Check the IAC valve ( idle air control ) maybe dirty and sticking. Clean with intake..."
Anonymous posted an answer for this GMC Cars & Trucks:
"92 gmc s-15 jimmy 4.3 z vin. dies when in drive at idle. It acts like it is running rich...."
Anonymous posted an answer for this 1998 Oldsmobile Silhouette:
"Have the CV joint checked for play & ware."
Anonymous posted an answer for this 1998 Oldsmobile Silhouette:
"thumping in the passer side front end when taking off in foward or reverse. Already change..."
Anonymous posted an answer for this 2006 Chevrolet Cobalt:
"6.5 round front 6x9 rear"
Anonymous posted an answer for this 2006 Chevrolet Cobalt:
"what size speakers are in the front doors of a 2006 chevy cobalt ls"
Anonymous posted an answer for this 1991 Chevrolet S-10 Blazer:
"On the drivers side left of the brake pedal up under dash on fire wall,gage cluster needs..."
Anonymous posted an answer for this 1991 Chevrolet S-10 Blazer:
"looking for location of fuse panel. I have the electrical dashboard and it went out, any..."
Anonymous posted an answer for this 2001 Volkswagen Jetta TDI:
"You may have a CV joint going,check and see if boot is torn or cracked and grease has..."
Anonymous posted an answer for this 2001 Volkswagen Jetta TDI:
"I have a 03 jetta 1.8t. When i turn right, it recently started to make a grinding noise,..."
Anonymous posted an answer for this 1994 Chevrolet S-10:
"Check fuel pressure,fuel pump maybe on the way out."
Anonymous posted an answer for this 1994 Chevrolet S-10:
"94 s10 with 4.3 w, starts fine,idles fine,but driving down the road it seems to misfire...."
Anonymous posted an answer for this 2004 Chevrolet Silverado 2500HD:
"Check the harness plugs under box on driver side near bumper all rear lights plug in..."
Anonymous posted an answer for this 2004 Chevrolet Silverado 2500HD:
"right rear tail light not working or back up lights. bulbs work and no blown fuses"
Anonymous posted an answer for this 1999 Plymouth Breeze:
"engine changes from 750 to 2000 rps by its self."
Anonymous posted an answer for this 1999 Plymouth Breeze:
"Try changing IAC VALVE ( idle air control) on throttle body, dirty and sticking. You can..."
Anonymous posted an answer for this 2004 Chevrolet Silverado 2500HD:
"where is knock sensor located on 2004 chevy 2500HD 6.0?"
Anonymous posted an answer for this 2004 Chevrolet Silverado 2500HD:
"Under intake manifold on top of block,you need to remove intake to access sensors there..."
Anonymous posted an answer for this 2005 Chevrolet Equinox:
"sometimes when i start my 2005 equinox i have to press the gass pedal for the engine to..."
Anonymous posted an answer for this 2005 Chevrolet Equinox:
"The IAC VALVE ( idle air control ) is sticking probabley dirty, try cleaning with throttle..."
Anonymous posted an answer for this 1999 Chevrolet Silverado 1500:
"The cover comes off from the top down, two clips one on the side by window other on top..."
Anonymous posted an answer for this 1999 Chevrolet Silverado 1500:
"I can't get inside door cover off to plug new cable into location.without damaging"
Anonymous posted an answer for this 1992 Cadillac Seville:
"whats the normall temp"
Anonymous posted an answer for this 1992 Cadillac Seville:
"190-200 degrees fahrenheit"
Anonymous posted an answer for this 1991 Oldsmobile Cutlass Supreme:
"My car has a coolant leak behind starter, do you think it might be the drain plug?"
Anonymous posted an answer for this 1991 Oldsmobile Cutlass Supreme:
"You have a frost plug leaking."
Anonymous posted an answer for this 2005 Chevrolet Equinox:
"The brake lights and head lights keep going out. Every other month or even more they need..."
Anonymous posted an answer for this 2005 Chevrolet Equinox:
"When running check voltage at battery raise idle speed and see if voltage goes over 14.8..."
Anonymous posted an answer for this 1992 GMC Jimmy:
"Try cleaning the IAC VALVE in the opening in the throttle body with throttle body..."
Anonymous posted an answer for this 1992 GMC Jimmy:
"I have a TBI 4.3 engine code Z in my jimmy and recently rebuilt it. All the vacume lines..."
Anonymous posted an answer for this Cars & Trucks:
"The shift solenoids are on the valve body inside the transmission, you need to remove the..."