Press enter to search.
If I know, I'll tell you.
Anonymous posted an answer for this Televison & Video:
"Make sure the speakers aren't turned off. It will be in the menu section under audio or..."
"If it's bright green with light lines from side to side the green gun is shorting out. You..."
Anonymous posted an answer for this 1992 Honda Accord:
"The fuel pump relay is the most likely cause of your problem. On most Civic's it is under..."
Anonymous posted an answer for this Philips 42FD9932 42 in. Plasma Television:
"If the back was off the board on the left is your Ysus board. It will have a cable plugged..."
"Change the STK 392 IC's on their heat sinks. Check for bad resistors in the area. Check..."
Anonymous posted an answer for this Philips Magnavox 27MS343S 27" TV:
"Try putting in a VCR tape let it load and hit stop. If the set stays on it's the VCR deck..."
"There are two identical IC's I think they are 18 pin more or less about half way up the..."
"The STK's are probably blown again. You need to pay close attention to the resistors..."
Anonymous posted an answer for this GE 25GT240 25" TV:
"The Flyback transformer is arcing. You could change it or if available replace the whole..."
"The Flyback Transformer is probably shorted to the core and shorted out the Horizontal..."
Anonymous posted an answer for this LG 32LX1D 32 in. LCD Television:
"At the top of the Signal module there may be a surface mounted resistor marked 100. It's..."
"You could try removing the ribbon cable directly under where the lines are from the X..."
"It is most likely the power supply. If you see domed caps change them using a higher..."
"Change the Capactors in the power supply yourself. Most of the time the tops of the bad..."
"Bad caps in the power supply. Replace all bad cap or replace Power Supply Module. If you..."
Anonymous posted an answer for this Philips 42PF9630A 42 in. Plasma Television:
"The Z sustain module blew it's transistors. It may have been initiated by the Y sustain..."
"The capacitors in the power supply are probably bad. The best way to check them in circuit..."
"Probably a bad picture tube but I would need more information like Brand and Type."
"If it is a older Zenith Big Screen and not a DLP ,LCD or Plasma, it would most likely be..."
"What Brand and Model do you have ? It sounds like your set is in shutdown and is blinking..."
Anonymous posted an answer for this RCA P61930BL 61" Rear Projection Television:
"NO !! You can't adjust that out. You have a convergence failure. You need to take it to a..."
Anonymous posted an answer for this Daewoo DP42SM 42 in. HD-Ready Plasma Television:
"It could be the panel but it could also be the ribbon cable that attaches to the display..."
Anonymous posted an answer for this RCA HD50LPW42 50" Rear Projection HDTV:
"Thats a DLP and those fans are noisy. Most of those fans are special and I don't think I..."
"If the tuner is not damaged many shops will replace it for you for $50. If you want to try..."
"The microswitchs are probably leaky. Ask your local TV shop what they would charge to..."
Anonymous posted an answer for this RCA P61960 61" Rear Projection Television:
"Check all three CRT modules for cracks. It would be between the CRT pins and the connector..."
"That sounds like a Pincushion problem if you having bowing. It's probably bad caps and..."
"Contact TV shops around your area. Most shops will sell you a good used one for a hundred..."
"It will depend on the Chassis number you have but it sounds like a bad Deflection module..."
"The Micro switches are leaky. They are soldered on the control panel in the front. Either..."
8,231 people helped
View all achievements