FCC Licensed, NMEA Cetified Radars and AutoPilots
John Barry posted an answer for this Furuno Boating:
"This depends on the chip. A chart chip will be write protected, so never save any data..."
John Barry posted an answer for this Furuno Boating:
"This requires a secret dealer only pass word to enter the set up on the FA 150. Call..."
John Barry posted an answer for this Furuno 2.2kw 18" Radome:
"No, a quarter sized blank area around boat on lowest 1/8 mile range is normal. The dome..."
John Barry posted an answer for this Furuno 2.2kw 18" Radome:
"Of course this could be many things, but it sounds like your auto clutter < labeled by..."
John Barry posted an answer for this Furuno 1832 Radar Devices:
"Magnetron has drifted out of tolerance, replace. Try manual tune and see if it is stable..."
John Barry posted an answer for this Furuno GP1920CBBNT NAVNET VX2:
"Sounds like a cartography issue. Does the Lat and Lon change or just the graphical..."
John Barry posted an answer for this Furuno Navnet 1834C/NT vx2 Radar C Map Nt:
"Maybe your compass is dead. did it ever work? JB 847-746-0100"
John Barry posted an answer for this Furuno Ls4100 5" Mono Lcd Fishfinder Temp And Depth:
"available online at furunousa.com"
John Barry posted an answer for this Furuno 1623 Radar 16nm Range:
"TXA and TXB are the two data lines. Confirm data present with digi meter then hook up. ..."
John Barry posted an answer for this Furuno Fcv1100 10.4 Color Lcd Sounder 1 Kw Model#Fcv1100:
"No, it has been translated from Japanese to Greek, then to Latin to English John..."
John Barry posted an answer for this Furuno NavNet 3D Hub:
"The NavNet 3D has a sonar module such as DFF1 or DFF3 or DFF1UHD. This is the fishfinder..."
John Barry posted an answer for this Furuno Fcv 1100 10.4" Color Fish Finder:
"Only experience will help you, try to turn down gain and up frequency to see..."
John Barry posted an answer for this Furuno DFF1 Digital Network Sounder for use with NavNet and NavNet vx2:
"Slow, not sure, weak al;lmost for sure it is the tarnsducer. Buy a new one and hang over..."
John Barry posted an answer for this Furuno Boating:
"Sure, no problem, just hook the talker wires from the Nav Man to the RX wires (yellow and..."
John Barry posted an answer for this Furuno 2.2kw 18" Radome:
"Must have RSB number and FCC ID number"
John Barry posted an answer for this Furuno Navnet 1834C/NT vx2 Radar C Map Nt:
"Either a weak magnetron, water in wave guide or most likely radar settings are not..."
John Barry posted an answer for this Furuno Boating:
"The bearing pulse generator is failed, cheap part, easy swap out. JB 847-746-0100"
John Barry posted an answer for this Raymarine E85001 PC/Seatalk/NMEA Interface Box:
"Use 18 guage wire for this box. Be careful to press directly on terminals to open..."
John Barry posted an answer for this Furuno 1650W/NT Gps Chartplotter C Map Nt Charts:
"You need a "House Battery" to run your electronics off of. Running the Fishfinder on the..."
John Barry posted an answer for this Furuno Ls4100 5" Mono Lcd Fishfinder Temp And Depth:
"my Furuno reads 3.5 feet when my sea ray depth finder reads 1.6 feet, how can i adjust..."
John Barry posted an answer for this Furuno Ls4100 5" Mono Lcd Fishfinder Temp And Depth:
"There is a keel offset or waterline offset that can be entered in the menus. Press "MENU"..."
John Barry posted an answer for this Furuno FCV 295 104" Fish Finder:
"I have a furuno FCV295 and when I was doing the initial installation set up of the..."
John Barry posted an answer for this Furuno FCV 295 104" Fish Finder:
"If you reset it and while in the Initial Settings" Menu, you press menu, it should take..."
John Barry posted an answer for this Uniden Oceanus VHF DSC Radio White:
"You must have hooked the speaker output from the VHF to the nmea output of the GP320..."
John Barry posted an answer for this Uniden Oceanus VHF DSC Radio White:
"Hi, I hooked up a furuno gps-320b to my oceanus dsc marine radio according to to the..."
John Barry posted an answer for this Furuno Fcv 585 Color Fishfinder:
"i have a furuno fcv 585 and have an airmar 1kw ss264n-20 with a 10F pin plug on the cable..."
John Barry posted an answer for this Furuno Fcv 585 Color Fishfinder:
"no, the ducer should have the diplexer built in to it. the matching box is for bare wire..."
John Barry posted an answer for this Raymarine Radar Cable, 25m, For 2kw Or 4kw Radomes, With Right Angle Connector:
"Hi. Looking for a new radar cable for Furuno 1720 say 5m to replace existing cable rather..."
John Barry posted an answer for this Raymarine Radar Cable, 25m, For 2kw Or 4kw Radomes, With Right Angle Connector:
"yes, this is available from Furuno give me an email address and we will quote can drop..."
John Barry posted an answer for this Furuno NavPilot 511 GPS Receiver:
"the rudder setup needs to be done. follow prompts, very common to be screwed up, read..."
John Barry posted an answer for this Furuno NavPilot 511 GPS Receiver:
"My furuno autopilot 511 has a rudder reference unit which worked and then stopped..."