Russ Wolterstorff posted an answer for this Precor Exercise & Fitness:
"The power switch on Precor treads is also a circuit breaker. If it trips when plugged in,..."
Russ Wolterstorff posted an answer for this Precor C956i Treadmills with HR / WholeSale:
"Sometimes a bad MCB will cause a vibration at certain low speeds. If you have another..."
Russ Wolterstorff posted an answer for this Precor Efx 576i Experience Elliptical Reconditioned:
"Does the lift work? If not, the battery is dead. Replace it."
Russ Wolterstorff posted an answer for this Precor 9.33 Premium Series Treadmill:
"Replace the overlay."
Russ Wolterstorff posted an answer for this Precor 9.21 Treadmill:
"There is a red magnet or insert that it used as a safety key. If you lost it, you will..."
Russ Wolterstorff posted an answer for this Precor EFX 5.17i Elliptical Fitness Crosstrainer [Discontinued]:
"Is the ramp steel or aluminum? (steel is magnetic, aluminum is not) If steel, the ramp..."
Russ Wolterstorff posted an answer for this Precor 9.27 Treadmill:
"Fuse is a dead end in this case. Is there belt movement with the LS error, where the belt..."
Russ Wolterstorff posted an answer for this Precor 954i Experence Series Treadmill "rebuilt":
"Verify voltage to the MCB. If it gets power, and 2 MCBs do not light up the console,..."
Russ Wolterstorff posted an answer for this Precor Exercise & Fitness:
"To update the software on Precor products, you will need Precor's proprietary software on..."
Russ Wolterstorff posted an answer for this Precor C956i Treadmills with HR / WholeSale:
"If rebooting the treadmill does not fix that, it may have a problem with the Autostop..."
Russ Wolterstorff posted an answer for this Precor 956i Experience Remanufactured:
"Even in a commercial environment, the batteries eventually go dead. Will they go dead..."
Russ Wolterstorff posted an answer for this Precor Efx 546 Version 1 Lower Body Elliptical Crosstrainer, 110v:
"One of those parts generally fixes that problem - have you tried contacting Precor? It..."
Russ Wolterstorff posted an answer for this Precor C954i Commercial Treadmill:
"Depends on what you mean by 'shuts off' . If it is resetting, it may not be getting..."
Russ Wolterstorff posted an answer for this Precor Efx 576i Experience Elliptical Reconditioned:
"Is the battery low?"
Russ Wolterstorff posted an answer for this Precor Efx 546 Version 1 Lower Body Elliptical Crosstrainer, 110v:
"If the battery is low usually the elevation will not work. Otherwise it should work ok."
Russ Wolterstorff posted an answer for this Octane Fitness Octane Q47 Elliptical Trainer:
"Sounds like it needs to be fixed. It will need a new left motor and cord most likely,..."
Russ Wolterstorff posted an answer for this Octane Fitness Exercise & Fitness:
"It should have wheels in the front - if you pick up the back, you can 'wheelbarrow' it..."
Russ Wolterstorff posted an answer for this Octane Fitness Octane xRide xR6 Seated Elliptical:
"Front right side - it may be hard to find - easier if you tilt it up a bit."
Russ Wolterstorff posted an answer for this Octane Fitness Q37c Elliptical Trainer:
"There is no on/off switch, if that is what you are asking. If it is plugged in, it should..."
Russ Wolterstorff posted an answer for this Life Fitness x5i Elliptical Cross-Trainer Refurbished:
"Contact Life Fitness to send it in for repair. Last I checked it is about $500. I do not..."
Russ Wolterstorff posted an answer for this Life Fitness X7 Elliptical w/Advanced Console Refurbished:
"If it clunks once per revolution, it could be the crank bearings. The brake would make a..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"Superlube for the incline screw. No other parts should be lubed."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"DO NOT PLUG THE DATA CABLE IN TO THE CSAFE PORT. It needs to be plugged into the 'lower..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"No please do not. If the wheels are noisy, they need to be replaced. If something else..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"It doesn't always say low battery - check the battery first. If the battery is fine, then..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"There may be a wave washer on the crankshaft that broke - when it breaks, there is too..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"Battery operated 546s have a fuse on the lower board, plug in models have a fuse on the..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"If the display stays at 1, then the UP button may be at fault, in which case you would..."
Russ Wolterstorff posted an answer for this Precor Exercise & Fitness:
"Then pedal faster..... If you are pedalling fast enough, the battery may be low."
Russ Wolterstorff posted an answer for this Precor Exercise & Fitness:
"Sounds like you have a Life Fitness machine, not a Precor. If it does not light up, check..."
Russ Wolterstorff posted an answer for this Precor EFX 546i Elliptical Version 4:
"If it does not plug in, yes, I would check the battery first."