1
rage-n-ron posted an answer for this Cars & Trucks:
"If a GM chassis and problem is dash air, remove the power wire from blower (under hood)..."
rage-n-ron
rage-n-ron posted an answer for this Bosch HME9760 Microwave Oven:
"Did you check the original fuse for continuity? Do so with an ohm meter if not. Does the..."
rage-n-ron
rage-n-ron posted an answer for this Dragon W. Lim Corp. Series 2hp Pump:
"If screw is rusty spray it down with rubbing alcohol, let it sit for awhile, then try to..."
rage-n-ron
rage-n-ron posted an answer for this Maytag Washing Machines:
"I don't know these front loaders so well but, here's a couple of things to look for. 1)..."
rage-n-ron
rage-n-ron posted an answer for this Kenwood Car Audio & Video:
"1) Pull your speaker wires, grab an ohm meter and confirm that each speaker reads 4-8 ohms..."
rage-n-ron
rage-n-ron posted an answer for this 1998 Volkswagen Passat:
"Have someone run a computer scan first. Most likely you will find a defective tiptronic..."
rage-n-ron
rage-n-ron posted an answer for this 1991 Honda Accord:
"Pull the mains relay up to the left of dash board. Remove cover from relay assy and check..."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"Trade #2 & #3 plug wires. If you loose fire on #2, you have a bad wire if not, replace..."
rage-n-ron
rage-n-ron posted an answer for this 1992 Ford Ranger:
"Find it & unplug it."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"Did you open the relay assy? If not, resolder the relays. Very common problem."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"Pull the radio then call a Honda dealer with model, serial number & vin to your car...."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"If you have a solder iron you can open up the relay can and re-solder the relay on the..."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"Is there vibration in steering wheel? Check for bent wheel then check axle...again. Remans..."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"Check lights on shift indicator. If missing or blinking, replace shift solenoids. If not..."
rage-n-ronrage-n-ron posted an answer for this 1991 Honda Accord:
"Have you flushed trans? Other problems with these is the shift & linear solenoid pack...."
rage-n-ron
rage-n-ron posted an answer for this 2000 Honda Accord:
"If it is just the mirror that is broken & not the mount, locate a wholsale auto glass..."
rage-n-ronrage-n-ron posted an answer for this 2000 Honda Accord:
"What type of pads are you guys using? The number one complaint on cars is brake noise. One..."
rage-n-ronrage-n-ron posted an answer for this 2000 Honda Accord:
"Have fuel pressure checked at fuel rail, scan ecm for codes or replace fuel filter."
rage-n-ronrage-n-ron posted an answer for this 2000 Honda Accord:
"You can use Lube Guard friction modifier to convert Dexron 3 to Honda spec. It has a red..."
rage-n-ron
rage-n-ron posted an answer for this Akai PT4298HD Rear Projection Television:
"Get rid of these sets while they are working, that is my best advise. I've been repairing..."
rage-n-ron
Cars & Trucks 15 answers
Televison & Video 1 answer
Garden 1 answer
Car Audio & Video 1 answer
Washing Machines 1 answer
Microwave Ovens 1 answer
