appliance repair technician by trade
qvo523 posted an answer for this Kenmore Washing Machines:
"If you don't hear a click when you close lid, replace lid switch. If when in spin, you..."
qvo523 posted an answer for this Maytag Washing Machines:
"bad bearing"
qvo523 posted an answer for this Kenmore Washing Machines:
"If it has a UL error and very loud during spin, you may have a bad bearing. Check..."
qvo523 posted an answer for this Whirlpool Washing Machines:
"Yes, if it is a HE washer it is energy efficient, less water and electricity. It..."
qvo523 posted an answer for this Maytag Washing Machines:
"Too much detergent or wrong kind of detergent. If you use non HE detergent this will..."
qvo523 posted an answer for this Maytag Washing Machines:
"The F35 error is for a suds problem, wrong kind of detergent or too much. If this does not..."
qvo523 posted an answer for this Admiral Washing Machines:
"If your drain is not high enough, 39 inches, from the ground, it will siphon out. Also if..."
qvo523 posted an answer for this Washing Machines:
"With the lid open, try to turn tub by hand. If you can you may have a bad clutch. If you..."
qvo523 posted an answer for this Kenmore 1.7 Cu. Ft. Over The Range Microwave Oven, 85042:
"Use a putty knife to gently pry the black trim from around inside of door around glass. Be..."
qvo523 posted an answer for this Washing Machines:
"If you can move the agitator in both directions, you may just have some bad agitator dogs...."
qvo523 posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"Too much soap or wrong kind of detergent if HE washer. Run the washer empty with 2 tsp of..."
qvo523 posted an answer for this Washing Machines:
"You will need a 5/16 nut driver, phillips and flathead screwdriver. Remove endcaps on rh..."
qvo523 posted an answer for this Frigidaire Affinity ATF7000E Front Load Washer:
"There is a drain catch located inside the hose coming from the bottom of the tub to the..."
qvo523 posted an answer for this Kenmore 3.5 cu. ft. Front Load Electric Washer:
"If there is still water in the tub, you may have something stuck inside your drain pump...."
qvo523 posted an answer for this Kenmore Washing Machines:
"Tilt your washer back and check if the lower gearcase pulley is rubbing on the cover. You..."
qvo523 posted an answer for this LG Washing Machines:
"If your drain is not high enough the water will siphon out while filling. Check your..."
qvo523 posted an answer for this Roper RAX4233PQ Top Load Washer:
"If you don't hear a click when you close the lid, it could be the lid switch, if you hear..."
qvo523 posted an answer for this Kenmore 24032\24036 Top Load Washer:
"It sounds like you have a bad bearing, it is located in the gearcase. I've seen this..."
qvo523 posted an answer for this Maytag HAV3460AWW Top Load Washer:
"It sounds like the motor is heating up and tripping the overload. The squealing is..."
qvo523 posted an answer for this Whirlpool Estate TAWS750PQ 27-Inch Washer:
"Pull off dispenser cap if it has one or top cap. Underneath will be another cap to remove...."
qvo523 posted an answer for this Kenmore Washing Machines:
"It sounds like you have a bad lid switch. There is a tech sheet taped to the inside of the..."
qvo523 posted an answer for this Kenmore 24032\24036 Top Load Washer:
"Use a putty knife and slide under each corner to compress clips. The console should hinge..."
qvo523 posted an answer for this Kenmore HE2 Plus Front Load Washer:
"Main pcb failure, replace."
qvo523 posted an answer for this Kenmore Elite HE5t Washer:
"The top panel has 3 screw on the back, either 1/4 or T20 torx. Remove screws and the slide..."
qvo523 posted an answer for this Maytag Washing Machines:
"Pressure switch or a restriction in the hose from the pressure switch to tub. You may just..."
qvo523 posted an answer for this Kenmore HE2 Plus Front Load Washer:
"Main PCB failure, replace main control"
qvo523 posted an answer for this Whirlpool WTW6400SW Cabrio Washer:
"Long drain, check pump"
qvo523 posted an answer for this Whirlpool Washing Machines:
"That code is for a main control failure, only repair is to replace main pcb."
qvo523 posted an answer for this LG WM2016CW Front Load Washer:
"Check your owners manual, some models warranty the rear tub that houses the bearing and..."
qvo523 posted an answer for this Washing Machines:
"There is a tech sheet on the front panel on the inside left upper corner, it is in a..."
qvo523 posted an answer for this Washing Machines:
"With the lid open there should be a small opening on the top where the plunger on the lid..."