Jim posted an answer for this Peltor Radio Communications:
"Sounds like the mic element went bad or the wire from the mic element is broken/fallen off..."
Jim posted an answer for this Radio Communications:
""
Jim posted an answer for this Icom Radio Communications:
"The RX light should light up when receiving a signal. It may be your squelch setting is..."
Jim posted an answer for this Radio Communications:
"It sounds like you are using the wrong mic for the radio or the mic has been wired..."
Jim posted an answer for this ICOM Informatique Icom IC-F11 5W 16ch VHF transceiver 2-Way Radio:
"First does it blow the fuse immediately when you turn it on or does it blow the fuse when..."
Jim posted an answer for this Yaesu Radio Communications:
"You mean FT-225RD not DR ? The RD is a base station all mode 2 meter rig. Older..."
Jim posted an answer for this Radio Communications:
"There were different wiring schematics for the various models of D-104 mics. Amplified..."
Jim posted an answer for this Icom Ic-7000, 706, 703, 718, 78 Amp Relay Cable:
"There were different wiring schematics for the various models of D-104 mics. Amplified..."
Jim posted an answer for this Icom IC-V8000:
"Many amateur radios come from the factory with the ability to receive many frequencies..."
Jim posted an answer for this Midland Radio Communications:
"I think you meant 70-0351c? I believe this is a 60 watt transceiver. So if you remember..."
Jim posted an answer for this Radio Communications:
"What is the model number?"
Jim posted an answer for this Radio Communications:
"Depending on where you live, your county may have decided to go to the new 800 mhz band. ..."
Jim posted an answer for this Cobra Radio Communications:
"If it "keys up" without a mic plugged in, try plugging the mic into the radio and see if..."
Jim posted an answer for this Galaxy Radio Communications:
"Each channel is a AM carrier frequency which is the center frequency of the channel. Each..."
Jim posted an answer for this Radio Communications:
"That is because it is a 10 meter Ham Band Transceiver and you need a Amateur radio license..."
Jim posted an answer for this Radio Communications:
"Check what the internal battery voltage is."
Jim posted an answer for this Radio Communications:
"usually indicates a high swr. Make sure antenna is not shorted anyway. Not metal close to..."
Jim posted an answer for this Icom Ic-2300h W/ 5/8 Antenna Truck Mount/replace Ic-2200h:
"If it says "OFF" it may be an indication you are trying to transmit on frequencies outside..."
Jim posted an answer for this Midland Radio Communications:
"Not on FRS. FRS has only one power level and it's set to low. GMRS ERP output on the 1050..."
Jim posted an answer for this Cobra Radio Communications:
"Make sure the antenna has a good gound at its base and make sure nothing is touching the..."
Jim posted an answer for this Radio Communications:
"check mic cable and plug. Make sure it is secure. Make sure cable is not broken. WHAT..."
Jim posted an answer for this Radio Communications:
"Is the d104 a amplified tug8 (4 wire) or tug9 (6 wire)
or is it a non amplified..."
Jim posted an answer for this Radio Communications:
"Go to the following url and download the..."
Jim posted an answer for this Kenwood Radio Communications:
"Watch ebay or QRZ.com for a used/non working unit that has a good display or maybe someone..."
Jim posted an answer for this Radio Communications:
"Give us more information please, what model and make of scanner, etc. Also, if the scanner..."
Jim posted an answer for this Uniden Radio Communications:
"Make sure the volume is up a little and then make sure the squelch is set so you do not..."