If its not broken.....Don't fix it
paulmacintyre posted an answer for this Ford Cars & Trucks:
"Check for any sources of unmetered air entering the engine. ( Vacuum leaks ). Check air..."
paulmacintyre posted an answer for this Cars & Trucks:
"Start with a proper diagnostic scan using a quality scan tool. Cheap scan tools may not..."
paulmacintyre posted an answer for this 1992 Honda Accord:
"If you want all door locks disabled, remove the fuse. If you want only one disabled, you..."
paulmacintyre posted an answer for this Chevrolet Cars & Trucks:
"If you are replacing the starter with another, you may require the use of shims. These are..."
paulmacintyre posted an answer for this Chevrolet Cars & Trucks:
"Grinding noises from the starter are usually caused by a defective starter drive gear and..."
paulmacintyre posted an answer for this Cars & Trucks:
"There are numerous reasons for a vehicle to stall at random. Is the check engine light on?..."
paulmacintyre posted an answer for this Dodge Cars & Trucks:
"If the relay and fuse are ok, there may be a power supply missing at the relay wiring..."
paulmacintyre posted an answer for this Jeep Cars & Trucks:
"If you are not familiar with this repair or have a weak mechanical background, have it..."
paulmacintyre posted an answer for this Cars & Trucks:
"Have you checked fuel pressure? Possible weak pump"
paulmacintyre posted an answer for this Subaru Cars & Trucks:
"This vehicle will not have a transmission filter as it is a standard transmission. If you..."
paulmacintyre posted an answer for this Cars & Trucks:
"If leaking at the caliper side, make sure the 2 copper gaskets are installed. One on each..."
paulmacintyre posted an answer for this Cars & Trucks:
"Year/make/model? Possible worn sway bar links/bushings causing this noise. Have the front..."
paulmacintyre posted an answer for this Ford Cars & Trucks:
"Is the distributor shaft turning when the vehicle is cranked?"
paulmacintyre posted an answer for this 2004 Ford Ranger:
"Most common is a bad signal light/multifunction switch failure. The brake lights are wired..."
paulmacintyre posted an answer for this Cars & Trucks:
"You should be safe with 16-18 thousands/inch"
paulmacintyre posted an answer for this Cars & Trucks:
"How long does it run for? Is it equipped with a security system and if so, is the security..."
paulmacintyre posted an answer for this Cars & Trucks:
"Year/make/model? If you have no power assist in either direction when turning the steering..."
paulmacintyre posted an answer for this Cars & Trucks:
"This light comes on when the vehicles computer detects a problem with one of the systems..."
paulmacintyre posted an answer for this 2006 Chrysler 300:
"You need to scroll through the functions on the instrument panel display until you find..."
paulmacintyre posted an answer for this Kia Cars & Trucks:
"No adjustments available for this model. These clutch systems are hydraulic"
paulmacintyre posted an answer for this Kia Cars & Trucks:
"Possible plugged exhaust system causing high back pressure causing this problem. Most..."
paulmacintyre posted an answer for this Kia Cars & Trucks:
"Possible defective crankshaft sensor. Have you checked for any diagnostic trouble codes?..."
paulmacintyre posted an answer for this 1991 Honda Accord:
"If you changed the oil pressure switch and the light remains on, you may have a low oil..."
paulmacintyre posted an answer for this Hyundai Cars & Trucks:
"You need to check 2 fuses. # 24 and #29 in the fuse panel inside the vehicle. Both these..."
paulmacintyre posted an answer for this Buick Cars & Trucks:
"If you have absolutely NO electrical power to ANYTHING suspect a battery cable issue. Try..."
paulmacintyre posted an answer for this Cars & Trucks:
"What make/model???"
paulmacintyre posted an answer for this Cars & Trucks:
"year/make/model?? Are you looking for the throttle actuator motor fuse or throttle body..."
paulmacintyre posted an answer for this Cars & Trucks:
"No problem..... For what?????"
paulmacintyre posted an answer for this 2002 Ford Explorer:
"Possible bad ground connection at headlight wiring connector. Check for any burned/loose..."
paulmacintyre posted an answer for this Cars & Trucks:
"If the noise appears to come from under the hood/engine area, suspect a bearing in one of..."
paulmacintyre posted an answer for this 1993 GMC Sierra K1500:
"Sounds as if the clutch is no good or is engaged constantly. Possible clutch worn out or..."