Matthew Ward posted an answer for this Maytag Washing Machines:
"Check the water flow coming out of your water valves on the wall. Once in awhile a faucet..."
Matthew Ward posted an answer for this Refrigerators:
"Most water softeners take out only "trace" amounts of iron or manganese. They are designed..."
Matthew Ward posted an answer for this LG LFX25960ST Stainless Steel French Door Refrigerator:
"https://lgtechassist.com/kms/index.php?View=entry&EntryID=6937 You may have to have a..."
Matthew Ward posted an answer for this Whirlpool Washing Machines:
"http://www.appliancepartspros.com/whirlpool-motor-2-speed-wp661600-ap6010250.html WP661600..."
Matthew Ward posted an answer for this Samsung DV218AEW Electric Dryer:
"https://www.youtube.com/watch?v=7jY609cz9-A"
Matthew Ward posted a question about GE Refrigerators:
"motherboard failure"
Matthew Ward posted an answer for this Washing Machines:
"WATER TEMPERATURE SENSOR ERROR If the water temperature sensor (NTC) value is out of range..."
Matthew Ward posted an answer for this Dishwashers:
"The dishwasher needs to be pulled out,disconnected from the power, water and drain. The..."
Matthew Ward posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"There is a small access panel on the bottom of these newer Maytag and Whirlpool washers...."
Matthew Ward posted an answer for this Washing Machines:
"First of all, the model is 110.21302010. The splined clutch called a splutch is slipping...."
Matthew Ward posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"http://foggyfacts.blogspot.com/2011/04/duet-he-front-load-washer-ghw9150p-tech.html Try..."
Matthew Ward posted an answer for this Whirlpool Washing Machines:
"Whirlpool, and other frontloaders have an inherent problem- They all have shaft seal and..."
Matthew Ward posted an answer for this Kenmore Washing Machines:
"If it is a top loader, you have to remove the agitator, then get a spanner nut wrench and..."
Matthew Ward posted an answer for this Washing Machines:
"Rotating blinking lights in the display is probably an indication that the Wrinkle Prevent..."
Matthew Ward posted an answer for this Whirlpool Washing Machines:
"If the washer is a top loader, then it probably is a broken lid switch, or blocked pump. ..."
Matthew Ward posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"Remove the panel beneath the door (2 or 3 screws). Reach up, there is a little "ring"..."
Matthew Ward posted an answer for this Whirlpool LSB6200KQ Top Load Washer:
"Check the motor to transmission coupling, probably broken. Also check the inner basket..."
Matthew Ward posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"Check the pump. Sometimes the plastic impeller gets stalled out from debris, or the..."
Matthew Ward posted an answer for this Whirlpool WFW8500SR:
"Replace the door interlock/switch assembly. Occasionally the control board goes bad, but..."
Matthew Ward posted an answer for this Whirlpool Ultimate Care II LSQ9564J Top Load Washer:
"Check the inlet valve screens, in back. Clean them out. If you are inclined to checking..."
Matthew Ward posted an answer for this Frigidaire FRS3R5EMB Side by Side Refrigerator:
"The plastic feed line from the inlet valve in the bottom right hand side of the back going..."
Matthew Ward posted an answer for this Samsung RS2630SH Side by Side Refrigerator:
"I am an authorized Samsung service company, and, according to my diagnostic code quick..."
Matthew Ward posted an answer for this Samsung RS2630SH Side by Side Refrigerator:
"I am an authorized Samsung service center, and I have dealt with this ongoing design..."
Matthew Ward posted an answer for this Samsung RS2630SH Side by Side Refrigerator:
"I am an authorized Samsung service center, and I have dealt with this ongoing design..."