Jim Rus posted an answer for this 2001 Toyota Avalon:
"Timing belt."
Jim Rus posted an answer for this 2008 Toyota Avalon:
"Try in the bottom of the center console."
Jim Rus posted an answer for this 2000 Toyota Avalon:
"Open it remotely? Two clicks on the remote. Internally, child safety locks located on..."
Jim Rus posted an answer for this 2002 Toyota Avalon:
"Tough to tell from your description. I would check the strut mount. That is the top..."
Jim Rus posted an answer for this 2005 Ford Expedition:
"Check the MAF sensor."
Jim Rus posted an answer for this 2003 Ford Expedition:
"Depends on the year, but many are on drivers side, high. Should not be able to miss them."
Jim Rus posted an answer for this 2001 Ford Expedition:
"I am guessing that you are speaking of a noise in the front and this is a 4x4? If so,..."
Jim Rus posted an answer for this Ford Cars & Trucks:
"You are pretty good at this! Replace the belt, but don't buy a cheap one. The belt slips,..."
Jim Rus posted an answer for this Ford Cars & Trucks:
"You need a good battery. It should read 12.6v while not running and 13.5v + while running...."
Jim Rus posted an answer for this Ford Cars & Trucks:
"All of the plastic simply pulls apart, but be careful to pull straight out. The plastic..."
Jim Rus posted an answer for this 1998 Ford Expedition:
"Nope, they do not!"
Jim Rus posted an answer for this Ford Cars & Trucks:
"The switch is a common problem and replacement is easy. The harness, improbable. You..."
Jim Rus posted an answer for this Jaguar Cars & Trucks:
"You have either a faulty diaphragm for the blend door or a leaking vacuum hose connecting..."
Jim Rus posted an answer for this Cars & Trucks:
"You have either a faulty diaphragm for the blend door or a leaking vacuum hose connecting..."
Jim Rus posted an answer for this Lincoln Cars & Trucks:
"The #3 cylinder is at the rear right of the engine. There is 1 coil located at each..."
Jim Rus posted an answer for this Ford Cars & Trucks:
"Sure you can tap it, hard. Then check soleniod and wire ends an well as engine ground. ..."
Jim Rus posted an answer for this Ford Cars & Trucks:
"The E series is the same until model..."
Jim Rus posted an answer for this Ford Cars & Trucks:
"Not too difficult. Hub and rotor are one if OEM. After removing the hub and placing the..."
Jim Rus posted an answer for this Beltronics Vehicle Parts & Accessories:
"Best that I could do. One of these should be similar. Good luck. ..."
Jim Rus posted an answer for this Cobra Vehicle Parts & Accessories:
"Here you go... http://auto.manualsonline.com/manuals/mfg/cobra_electronics/xrs..."
Jim Rus posted an answer for this Cobra Vehicle Parts & Accessories:
"Wrong adapter"
Jim Rus posted an answer for this Cobra Vehicle Parts & Accessories:
"Wrong adapter"
Jim Rus posted an answer for this Blade Saws:
"I believe that you are correct. Your blade would break if your cut was deeper than the..."
Jim Rus posted an answer for this Ryobi Saws:
"Push down on the handle, a spring load pin should move out. Mine is on the left side where..."
Jim Rus posted an answer for this Cars & Trucks:
"I agree !"
Jim Rus posted an answer for this Ford Cars & Trucks:
"Can't tell you the location, but it is the high pressure line and is a sensor that screws..."
Jim Rus posted an answer for this Cars & Trucks:
"Need more info. Most PB work off of engine vacuum, vacuum booster."
Jim Rus posted an answer for this 1996 Buick Park Avenue:
"I think that you just answered your own question. Good luck."
Jim Rus posted an answer for this Volvo Cars & Trucks:
"???"
Jim Rus posted an answer for this Dodge Cars & Trucks:
"A vibration when accelerating is almost always related to drive train. Check the U-joints..."
Jim Rus posted an answer for this Chevrolet Cars & Trucks:
"Check the modulator and the vacuum line to it."