I have 10 yrs on working on Polaris ATVs
Brad Hurt posted an answer for this 2000 Yamaha XVS 650 Dragstar:
"Check for an intake leak around carb and head"
Brad Hurt posted an answer for this 2002 Yamaha YZ 426 F:
"Your clutch is not fully disengaging.Adjust the cable at the lever until you have plenty..."
Brad Hurt posted an answer for this 2003 Yamaha WR 450 F:
"MAke sure your tank vent is clear.If so you need to pull the carbs and clean the passages..."
Brad Hurt posted an answer for this 2005 Harley Davidson FLHRS - FLHRSI Road King Custom:
"Have the steering post bearings tightened"
Brad Hurt posted an answer for this 1979 Harley Davidson XLS 1000:
"Find the closest bar and have a couple beers wait for it to stop raining. Then ride very..."
Brad Hurt posted an answer for this 2005 Harley Davidson XL 1200 C Sportster Custom:
"If you are not running an open or free flowing exhaust go back to the stock size jets but..."
Brad Hurt posted an answer for this 2002 kawasaki KMX 125:
"Check the piston to cylinder clearance.You very well could have wore either the piston..."
Brad Hurt posted an answer for this 2000 Harley Davidson FXDWG Dyna Wide Glide:
"If this started after the rear wheel replacement recheck the allinement of the wheel it..."
Brad Hurt posted an answer for this 2003 kawasaki KX 250:
"Check gas cap vent by running with cap loose.If this clears it up go with a new cap and..."
Brad Hurt posted an answer for this 2004 Harley Davidson XL 883 Sportster:
"With just this info.Not knowing if the engine is stock or has bigger cams or high comp..."
Brad Hurt posted an answer for this 2000 Harley Davidson XL 1200 C Sportster Custom:
"You have a basic EVO designed engine with a CV carb.I dont think they have a TC Sportster..."
Brad Hurt posted an answer for this 1983 kawasaki KE 125:
"First check the engine compression with a gauge.It should be over 100psi.If not either the..."
Brad Hurt posted an answer for this 1988 Honda CBR 600 F(1)J:
"Take the forks apart and replace the fork tubes with shorter ones or change to a different..."
Brad Hurt posted an answer for this Harley Davidson Harley-Davidson Motorcycle Desktop Telephone:
"Take the master cylinder off the bike and try to "bench bleed" it in a vise.Fill with..."
Brad Hurt posted an answer for this Polaris ATV:
"First off you are correct in the front to rear ratio has to be the same as stock.But some..."
Brad Hurt posted an answer for this 1993 Harley Davidson XLH Sportster 883:
"I think I ciphered enough french to help you.1st make sure the AWD light bulb is..."
Brad Hurt posted an answer for this 2008 Harley Davidson FLTR Road Glide:
"two other things that havent been mentioned are if you are still running a primary chain ..."
Brad Hurt posted an answer for this 2000 Yamaha TT 600 R:
"Pull the carb off.Take the bowl off,take the pilot jet( the small one )out and clean ALL..."
Brad Hurt posted an answer for this 1979 Harley Davidson XLH 1000 Sportster:
"On the older Sportsters you check the chain for freeplay on bottom.shuold be 1in - 1 1/2..."
Brad Hurt posted an answer for this 1979 Harley Davidson XLS 1000:
"My best advice on this would be take a Motorcycle Safety Course Then wear a good..."
Brad Hurt posted an answer for this 2005 Harley Davidson VRSCB V-Rod:
"I disagree with having to change sprockets for a new chain.I ride a old Harley that I have..."
Brad Hurt posted an answer for this 2005 Honda CR 125 R:
"Sometimes they will hang between gears and cause this.Put it in 2nd and rock it back and..."
Brad Hurt posted an answer for this 1998 Honda XR 400R:
"Yes you can change your XR400 to electric start. Just find a parted out 400EX 4wheeler.It..."
Brad Hurt posted an answer for this Harley Davidson Harley-Davidson Motorcycle Desktop Telephone:
"Sounds like a timing issue. If you have points set them to .018 and then static time the..."
Brad Hurt posted an answer for this 2003 Harley Davidson FLSTFI Fat Boy:
"The newer Harleys are not as critical on maintenance as the older ones.But any motorcycle..."
Brad Hurt posted an answer for this 2003 kawasaki KX 125:
"Not sure if you can swap out yrs of CDIs but you can get a reprogramed CDI from Procom.It..."
Brad Hurt wrote a tip for 2003 kawasaki KX 125:
"Not sure if you can swap out yrs of CDIs but you can get a reprogramed CDI from Procom.It..."
Brad Hurt posted an answer for this 1981 Suzuki TS 185:
"The air screw should start at 1 1/2-2 turns out. The idle screw should be where it just..."
Brad Hurt posted an answer for this 1983 Volkswagen Rabbit Pickup:
"They make a tool that hooks into the ears of the clamp and compresses the clamp so you can..."
Brad Hurt posted an answer for this 2005 Suzuki TF 125 Mud Bug:
"I would drain it ASAP!Most likely it got in through the vent line.Not sure where the..."