Anything short of doing the job right is a waste of time.
Steven A posted an answer for this 2001 GMC Jimmy:
"There might be a chunk of carbon stuck in the valve, holding it open. Happened to a buddy..."
Steven A posted an answer for this 2005 Ford Taurus SEL:
"A common cause for stalling is the IAC system. If the IAC is carboned up it will not allow..."
Steven A posted an answer for this 2001 Mitsubishi Eclipse GT:
"The clutch is not releasing properly for some reason. A number of things can cause this...."
Steven A posted an answer for this 2004 GMC Yukon:
"Sounds like you're talking about the heater hose spigot. If it's just the plastic clip..."
Steven A posted an answer for this 2000 Toyota Corolla:
"Hi there, Sounds like the shifter cable has fallen out of adjustment. Lift up the car and..."
Steven A posted an answer for this Chevrolet Cars & Trucks:
"If I were to wager a guess, I'd say that it could be an ABS trouble code."
Steven A posted an answer for this 1988 Chevrolet Silverado 2500:
"That truck should have a spark plug gap of 0.035 inch."
Steven A posted an answer for this Chevrolet Cars & Trucks:
"You will need an impact driver to get that screw out, if it won't come out with an..."
Steven A posted an answer for this 2006 Mazda 3:
"If you can't manage to unlock the door with a slim jim or something like that, then you..."
Steven A posted an answer for this 1990 Buick LeSabre:
"I imagine it ought to be located in the ashtray on one side. That is where it is on my GMC..."
Steven A posted an answer for this Mazda Cars & Trucks:
"It means that the computer has lodged trouble code(s) in its memory. First step is to..."
Steven A posted an answer for this Cars & Trucks:
"Check engine compression, should be around 150 PSI for each cylinder, but if you have at..."
Steven A posted an answer for this Cars & Trucks:
"You will have to check to see if you're missing spark or fuel when it won't start."
Steven A posted an answer for this Cars & Trucks:
"Sounds like you have already diagnosed the problem, Denise. Replace the broken switch and..."
Steven A posted an answer for this 2001 GMC Sonoma Extended Cab:
"Make sure the engine grounds are good, very important on these trucks. Also check the..."
Steven A posted an answer for this 1989 GMC K1500:
"Spark plugs are set at 0.035 inch. Ignition timing is set at 0 degrees BTDC. The computer..."
Steven A posted an answer for this 1990 Buick LeSabre:
"If the alternator and battery are good, then clearly you have a wiring/connection issue of..."
Steven A posted an answer for this Volvo Cars & Trucks:
"If there is condensation building up under the distributor cap, perhaps the cap is not..."
Steven A posted an answer for this Motorcycles:
"This will be a good source of info for Yamaha outboards:..."
Steven A posted an answer for this Cars & Trucks:
"Sounds like the speed sensor stopped working. Check the connector for it (it's at the back..."
Steven A posted an answer for this Cars & Trucks:
"If the axles are C-clipped in place, you will have to remove the differential cover to..."
Steven A posted an answer for this Chevrolet Cars & Trucks:
"Does it have spark??"
Steven A posted an answer for this 2000 Ford F350 Super Duty Super Cab:
"For some reason, you have excessive current draw. You need to determine why this is..."
Steven A posted an answer for this 2000 Ford Ranger SuperCab:
"Make sure the radiator is completely full. If it's not, that could be the issue."
Steven A posted an answer for this Toyota Cars & Trucks:
"Could be a bad vacuum booster. Disconnect it and plug the hose, and take it for a short..."
Steven A posted an answer for this Saturn Cars & Trucks:
"It should be at either the upper or lower radiator hose. If you see anything that looks..."
Steven A posted an answer for this Cars & Trucks:
"You might be burning it, or the antifreeze might be going into the engine oil. Let us know..."
Steven A posted an answer for this Cars & Trucks:
"It would be good to know what vehicle you are talking about, and what exactly you are..."
Steven A posted an answer for this Ford Cars & Trucks:
"Have someone lean on the hood as you pull the release, it might be jamming up somewhat. If..."
Steven A posted an answer for this Cars & Trucks:
"Sounds like some wiring possibly didn't get buttoned up quite right. Might want to recheck..."