3Not older, better
Andrew White posted an answer for this Poulan Garden:
"The only reason for the bulb to stick down is there is a fuel blockage, basically it..."
Andrew WhiteAndrew White posted an answer for this Garden:
"You need to pressure test the carb, if the needle is leaking in the seat it will just..."
Andrew White
Andrew White posted an answer for this Husqvarna Chain Saw 20" Bar:
"The return spring is not supposed to come out, however, remove the e clip and pull out the..."
Andrew WhiteAndrew White posted an answer for this Husqvarna Garden:
"The early 353 had a breather made up of two small,round white tablets that just pushed..."
Andrew WhiteAndrew White posted an answer for this Garden:
"I would suggest the piston has scuffed, remove the muffler and look at the exhaust face of..."
Andrew White
Andrew White posted an answer for this Husqvarna Lawn Tractor 48" Deck, 23 Hp, Model# Yth2348:
"Hydro units are pretty well sealed, if there is no leakage under the machine when left,..."
Andrew WhiteAndrew White posted an answer for this Garden:
"This is fuel starvation, clean/replace the fuel filter in the tank, check the fuel hose up..."
Andrew White
Andrew White posted an answer for this Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin:
"Could be the chainbrake is on, pull the hand guard fully back until the brake clicks off,..."
Andrew White
Andrew White posted an answer for this Husqvarna 28cc Gas Line Trimmer:
"The local Husqvarna agent is the best place to start, e bay is also a source of pattern..."
Andrew WhiteAndrew White posted an answer for this Husqvarna Garden:
"Check the piston is not scored by removing the muffler and looking through the open..."
Andrew WhiteAndrew White posted an answer for this Stihl Garden:
"There is no oil pump on a concrete saw, only on the chainsaw."
Andrew WhiteAndrew White posted an answer for this Garden:
"There is two wires from the ignition unit, an earth cut out and an earth return, by..."
Andrew WhiteAndrew White posted an answer for this Garden:
"If you are happy the carb is now ok and the plug gets wet with fuel, then either there is..."
Andrew WhiteAndrew White posted an answer for this Ryobi Garden:
"The old way was to throw it on the fire for an hour or so, this will burn out the carbon,..."
Andrew WhiteAndrew White posted an answer for this Garden:
"There is no adjustment on these small gearboxes, it is governed by the pulley sizes which..."
Andrew White
Andrew White posted an answer for this DR Power Equipment 8.00 PREMIER Electric Start Tow-Behind Leaf & Lawn Vacuum:
"The clutch brake is a non servicable item, you need to remove the motor, belt and brake..."
Andrew White
Andrew White posted an answer for this Stihl Chainsaw 42mm Piston Compression Ring 024 O24 Ms240 1118-034-3000:
"Torx T27 is the standard size used by Stihl"
Andrew White
Andrew White posted an answer for this Ryobi 18-inch Electric Chainsaw Chain Saws:
"Very often they use a spring as the filet, it sits on the end of the oil delivery tube..."
Andrew WhiteAndrew White posted an answer for this Husky Garden:
"This is a carb adjustment issue and needs to be rectified before using it again, the L jet..."
Andrew WhiteAndrew White posted an answer for this Garden:
"Chainsaw carbs have two working sides, the pump side and the metering side, the pump side..."
Andrew White
Andrew White posted an answer for this Briggs AND Stratton Intek Briggs & Stratton Vertical Engine 21 HP INTEK OHV 1 x 3-5/32 331877-3036 331977-0001:
"Most Briggs deco vaves are internal and pretty reliable, the valve clearances are very..."
Andrew White
Andrew White posted an answer for this Husqvarna Models 61-66, 266, 268, 272:
"Yes the brake will go straifght on with no problems."
Andrew WhiteAndrew White posted an answer for this McCulloch Garden:
"Part no. 92459 should be thr bar stud"
Andrew WhiteAndrew White posted an answer for this Stihl Chainsaw 42mm Piston Compression Ring 024 O24 Ms240 1118-034-3000:
"Most Stihl machines use Torq 30 head screws"
Andrew WhiteAndrew White posted an answer for this Garden:
"The hyro unit has two cylinder blocks, a variable displacment pump and a fixed motor..."
Andrew WhiteAndrew White posted an answer for this Husqvarna Garden:
"Fuel bulbs on chain saws pull fuel from the carb and dump back to the tank, so if the bulb..."
Andrew White
Andrew White posted an answer for this Black & Decker Black Decker NPP2018B 18 Volt Cordless Pole Chain Saw Bare Tool (No Bat:
"file should be a 5/32"
Andrew WhiteAndrew White posted an answer for this Garden:
"basic settings for this saw would be one turn out on both screws, these are base settings..."
Andrew White
Andrew White posted an answer for this Poulan Pro Chain Saw 46cc 20":
"Its either seized, or the rings are worn, either way you need to remove the cylinder to..."
Andrew WhiteAndrew White posted an answer for this Ryobi 18-inch Electric Chainsaw Chain Saws:
"The purge bulb always pulls fuel from the carb and dumps back to the tank."
Andrew White
Andrew White posted an answer for this Poulan 16" 38cc Gas Chain Saw P3816:
"91sg ( hobby chain ) needs a 5/32 file, the top plate should be 30 degrees"
Andrew White
Garden 2189 answers
Saws 30 answers
Measuring Tools & Sensors 4 answers
Tools & Hardware - Others 3 answers
Sport & Outdoor - Others 2 answers
Cars & Trucks 1 answer
Sewing Machines 1 answer
