2Over 25 years experience with domestic and import
Ron posted an answer for this 2008 Ford F-150:
"They are well known for the positive cable rotting off at starter ."
Ron
Ron posted an answer for this 1998 GMC Sierra:
"A bad coolant temp sensor for the ECM will cause that problem ... they are cheap and easy..."
Ron
Ron posted an answer for this 2002 Ford F150 Regular Cab:
"My f150 blows the fuse for the cruse control and the automiatick door locks and the over..."
RonRon posted an answer for this 2002 Ford F150 Regular Cab:
"Remove the plastic cover around the steering column and you will find the wire is broken..."
Ron
Ron posted an answer for this 1995 Buick Riviera:
"Check the brake fluid level .. It may be low causing the light but you may also have a..."
RonRon posted an answer for this 1995 Buick Riviera:
"parking brake light on and can't shut it off pedal is released"
Ron
Ron posted an answer for this 2002 Chevrolet Tahoe:
"Sounds like the fuel composition sensor is bad causing it to run rich .. Is your Tahoe a..."
RonRon posted an answer for this 2002 Chevrolet Tahoe:
"my 03 chevy tahoe has a code dhat is po179 is not pas inspection"
Ron
Ron posted an answer for this 1989 Chevrolet K1500:
"I'm not sure i understand what your asking exactly ...There is no bleeder on the power..."
RonRon posted an answer for this 1989 Chevrolet K1500:
"Where is the bleeder screw for a 1989 silverado/power steering"
Ron
Ron posted an answer for this 2005 Chevrolet Silverado:
"Multi function switch ( signal switch assembly ) is bad .. most part stores carry after..."
RonRon posted an answer for this 2005 Chevrolet Silverado:
"2003 siverado 2500hd-when i put on the left turn signal-the 4 ways go on.how big of a..."
Ron
Ron posted an answer for this 2000 Ford F250 Super Duty Crew Cabs:
"Remove the caliper from the caliper bracket and install caliper bracket on spindle ......"
RonRon posted an answer for this 2000 Ford F250 Super Duty Crew Cabs:
"does the caliper mounting braket bolts slide into the caliper to enable the caliper to..."
RonRon posted an answer for this 2003 Chevrolet Silverado 2500HD:
"po540 code"
RonRon posted an answer for this 2003 Chevrolet Silverado 2500HD:
"P0540 is a air intake heater code.... Most likely needs to be replaced. The intake air..."
Ron
Ron posted an answer for this 1996 Chevrolet Blazer:
"There is a cable that runs from the vacuum pot down to the front diff. .. I have seen them..."
RonRon posted an answer for this 1996 Chevrolet Blazer:
"i have a 1996 chevrolet blazer when i hit the four wheel drive button it locks the drive..."
RonRon posted an answer for this 1987 GMC S-15 Pickup:
"350 engine runs rough, low power, slight knocking, with no trouble codes - why?"
RonRon posted an answer for this 1987 GMC S-15 Pickup:
"I'm a little confused on this one because they were only available with V6 motors and if..."
Ron
Ron posted an answer for this 2004 Chevrolet Blazer:
"You have 4 sensors on that truck ... are you sure you replaced the correct ones ?"
RonRon posted an answer for this 2004 Chevrolet Blazer:
"2004 blazer 4x4 with a vorteck motor codes po135 and po155 bank 1 and 2 heat..."
RonRon posted an answer for this Dodge Cars & Trucks:
"You need a special puller / installer to remove the clutch on the a/c compressor.... It..."
RonRon posted an answer for this Dodge Cars & Trucks:
"need to change?? how do I change the bearings and clutch on ac compressor for the 1997..."
RonRon posted an answer for this Chevrolet Cars & Trucks:
"Are you sure it is fuel ? Those motors are known for bad intake gaskets leaking coolant..."
Ron
Ron posted an answer for this 2000 Chevrolet Blazer:
"Check the front wheel bearings .... very common . While driving turn the wheel gently from..."
RonRon posted an answer for this 2000 Chevrolet Blazer:
"Vibration NOISE in front end of 2000 Chevy Blazer. Any suggestions??"
Ron
Ron posted an answer for this 1995 GMC Jimmy:
"got stuck in the snow, engine died,would not start, for 3days, came back poured gas into..."
RonRon posted an answer for this 1995 GMC Jimmy:
"Sounds like you fouled a couple plugs ... change them out and go from there ."
RonRon posted an answer for this 1988 GMC Jimmy:
"Check the spring bushings for play ( front and rear ) .. I've seen this a few times and..."
RonRon posted an answer for this 1988 GMC Jimmy:
"88 K5 Jimmy 4x4 i replaced all the ball joints tierod ends shocks and stabilizer shock had..."
Ron
Cars & Trucks 249 answers
