Zebra Z - Recent Questions, Troubleshooting & Support - Page 3
HOW TO INCREASE PRINTHEAD HEAT
Press Setup/exit first option should be Darkness.
Press Select then the plus key.
Press setup/exit twice to exit and save.
Zebra Z4m printer
you can change the backfeed option under the driver settings, I would also turn you print speed up too (on same tab) it sounds to be set on 2.5ips, crank it up to 7ips or higher
best of luck
5/27/2015 11:22:13 AM •
Zebra Z4M...
•
Answered
on May 27, 2015
Zebra z4mplus blanck screen
Sounds like the main board needs replacing. Google '77904m PWB" and you will get a place to buy the part. However you mentioned the IP the Z4m does not have an Ethernet option so make sure that it isn't a Z4m+.
Flush problem zebra tlp2844
The firmware download utility program comes on the CD supplied with the printer. Use this to download the firmware file to the printer. Check on the zebra website for the latest firmware file. (You should be able to download the Download utility program from the website also. (Steady red may indicate that the printer is set to the incorrect operating mode. Check that you have the correct setting in your printer driver - Thermal Transfer if you use a ribbon, Direct Thermal if not) Easiest way to check is to insert a ribbon and see if printer works)
Z6m won't stop feeding
I would venture a guess that the sensor that detects the labels isn't working well - it's supposed to see the difference between label and backing paper and stop at the correct position.
I have a Z4M plus and it only prints half of the
Clean the print head. If half has got gummy from labels, it will not be able to print. You will need to use a solvent for the gummy adhesive... possibly Toluol... HOWEVER be very careful to keep that off ANY plastic parts.
Z4m printer error condition paper out labels will just keep feeding through ?
Sounds like a miss-match on the labels you are loading and the labels it is set up for. You'll have to go into the printer properties and check (and adjust as needed) the label stock selected to make sure they match. Next check the setting on the printer its self for the same for label stock selected. Most likely you're trying to use a label stock different then it was using before.
What are the specific steps to configure a Z6M
Printing in landscape or portrait !First of all you have to create a portrait page.When using the label programme select he page and tick the landscape option.When you print it will do the rotation.
6/24/2014 11:45:24 AM •
Zebra Z6M...
•
Answered
on Jun 24, 2014
Not finding what you are looking for?