York Exercise & Fitness - Recent Questions, Troubleshooting & Support
What can i do when i get a E2 error on my york packer 3800 treadmill
When you encounter an E2 error on your York Pacer 3800 treadmill, it typically indicates an issue with the speed sensor or the speed sensor circuit. Here are some steps you can take to troubleshoot and potentially resolve the E2 error:
- Power Cycle: Turn off the treadmill and unplug it from the power source. Wait for a few minutes and then plug it back in. Power it on and see if the error persists. Sometimes, a simple power cycle can clear temporary glitches and resolve the issue.
- Sensor Cleaning: Inspect the speed sensor, which is typically located near the drive motor. The sensor is responsible for detecting the speed of the treadmill belt. Check for any debris, dirt, or dust that may be obstructing the sensor's functionality. Clean the sensor and the surrounding area using a soft cloth or brush. Ensure that the sensor is properly aligned with the magnet on the pulley.
- Sensor Adjustment: If cleaning the sensor doesn't resolve the issue, it may require adjustment. Consult the user manual for your York Pacer 3800 treadmill or contact the manufacturer's customer support for guidance on how to properly adjust the speed sensor.
- Wiring Inspection: Check the wiring connections between the speed sensor and the console. Ensure that the connections are secure and there are no loose or damaged wires. If any wiring issues are detected, repair or replace the affected wires.
- Speed Sensor Replacement: If the error persists after performing the above steps, it is possible that the speed sensor itself is faulty and needs to be replaced. Contact the manufacturer's customer support or a qualified technician for further assistance. They can help you identify the exact replacement part and provide instructions on how to install it properly.
If none of the troubleshooting steps resolve the E2 error, it is recommended to contact York's customer support or consult a professional treadmill technician for further assistance. They will have specific knowledge and expertise to diagnose and resolve the issue with your York Pacer 3800 treadmill.
I have a York z16
LS or L5 error is the speed sensor. Because it is such a vague code I can't just tell you exactly what's wrong with it. I can tell you what it may be.
If you are lucky it's just a fuse. If you have belt movement, it's likely that its just a fuse. If there is no belt movement, it can be a computer failure. the MCB will need replacing.
If you have belt movement and you check the fuse, and its not blown, then the speed sensor is no good and needs replacement.
In most cases its a fuse.
Good luck, hope this helps!
Hi just wondering if anyone can help with a
hi,
Error E3 means speed sensor error.there is a sensor for checking and controlling the speed. check the speed sensor and its,connectors, clean the speed sensor. for that u have to open the motor cover.
ok
Not finding what you are looking for?