Yamaha WaveRunner FX Cruiser SHO - Popular Questions, Answers, Tips & Manuals - Page 2

It should have a rubber hub pressed into the prop. It can go bad and is in place of a shear pin. The rubber hub should allow the prop to turn at idle speed but will slip at higher speeds. You can get a new hub pressed into the old prop.

Might be simple. Did you leave the Nav lights on and run the battery down? The clicking means it wants to go but may not have any power.

Cracked block?

Either fuse, switch or pump itself. See your friendly mechanic

I think the model number can help you more for finding the year of manufacture. I couldn't find anything on the serial number. Also, if you contact a Yamaha outboard dealer, they can help you.

Yes

Yes

Yamaha Year Models This Yamaha outboard year model chart will only work for Asia Pacific distributed engines. If you have a Yamaha engine that has been bought in from America or Europe direct the parts will still be the same but your model and year model code will be different. You will have to use your own knowledge of your engine to select the appropriate year. For Asia Pacific engines your year model code is found on the bottom right hand corner of your serial number decal. It will be a single letter as per the diagram below which can then be matched to the chart. Note: The letters will repeat in the below chart so use your judgement as to the correct year, ie: the engine in the picture is a 2003 model and not a 1982 model. 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982 Z Y X W V U T S R 1983 1984 1985 1986 1987 1988 1989 1990 1991 1992 P L K J H G F D C 1993 1994 1995 1996 1997 1998 1999 2000 2001 2002 A Z Y X W V U T S R 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 Q P N K J H G F D C 2013 2014 B A

you will need to remove the carbs and clean them out. This may help:

Does it have spark when it cuts off?

What's leaking? More info would help.

https://www.youtube.com/watch?v=lWbp_tTRdiM thought some good info on this link https://www.youtube.com/watch?v=AGha-S0WVd4

Your motor has 2 cylinders.

is this a 20 hp?

Take off the motor cover and check the linkage to ensure the throttle return spring is not hung up on the choke linkage.

Go to a boat engine repair shop. They may be able to come up with one.

Sounds like a head gasket, worn valve gasket, as my first guess.

The carburetors are in desperate need of some PROFESSIONAL attention. They all stop up after sitting for that long.

There is an intake pipe on the water pump in the lower unit. Is this the one you are refering to? The water enters the lower unit through side screens and takes it directly into the pump. The pump impeller is driven directly by the driveshaft and is an easy replacement. I have the manual if you need the pages scanned.

YouTube video may be helpful