Stanley Garden - Recent Questions, Troubleshooting & Support

Question edited for clarity. Question moved to correct Stanley category. Amazon or Sprayer-Outlet https://www.google.com/search?q=top+seal+gasket+for+a+steel+STANLEY%2C+2+gallon+garden+spraYER ..

Chapin makes sprayers. They have parts. Just give model #. Phone 1-800-950-4458. Located in N Y STATE. Pump rebuild kit is $25.00 Inc shipping.

On the pivot end of the bladed knife is a black plug that says pull. They actually mean "Push". push it away from the knife body and rotate the handle half it's mounted in, down. The body will rotate in half , revealing the utility blade and more blades in the rear storage.Also note the blade depth adjustment has a locking detent. You have to push it to the right to unlock the utility blade.and push it to the right when retracting to fully retract and lock the utility blade.

Is tranny and various speeds working properly? How about the throttle control? Do you have it set for higher speed?

Not without a model number!

Try tilting the machine backwards for a few hours. It may be oil on the piston that is causing a vaccum

Hi Chris: Seems a bit extreme to consider using the 12 gauge. I've found that a .22 works quite well. (Humour) Hint! Pressurized tanks must have the pressure relieved BEFORE the lid can be removed. If the lid has been over tightened or has stuck, you'll need to get more leverage to unscrew it. Sometimes a rag wrapped around it is all it takes. You can also try pouring hot water over the cap. Lay the tank flat so the rim of the cap gets the heat. Wrap an old towel around it first so it gets a good hot soak. Should come off without the artillery. Cheers

Make sure it has the right amount of oil in the crank case, if over filled the oil will foam and flow out any place it can, Worn piston rings can cause blowby into the crank case , causing oil to escape from the dipstick tube.

The valve-o-rings + [ parbaks seals ] where the pressure can be adjusted with. Control the water inlet filter or hose that there are no waterlock couplers are used or is mounted on the wrong site on the hose , that it is used as water inlet on the tap.

This is a terrible tool took it apart to get the blade out of the handle and haven't been able to get it back together again.

Try manufacturer web site.