Sta Rite Pool & Spa - Recent Questions, Troubleshooting & Support


Check the control wire that might be connected to the control fuse. If that wire is open the unit will only cycle thru the board information and the sit dormant until the control is called for.

Sta Rite Pool &... | Answered on Jun 17, 2019


Water flow might be the issue. Check the Thermal Reg or any other external by-pass.

Sta Rite... | Answered on Apr 26, 2019


Thank you for posting your question here on Fixya.com.


Page 43 of your manual, found here suggests both E05 and E06 errors mean the issue is related to "...(the) fuel supply, thermal regulator, check for correct orifices, etc...". It also touches on the possibility that if the unit was converted from NG to PP or vice-versa that the orifices are not correct.


Start with these two areas...if you need additional assistance please comment to this answer with details from what you find while checking these areas and I'll try and help you from there.


If this answer does not fix your problem, please comment with additional details prior to rating the answer. You may also contact me thru our website at www.arrowpools.net. Positive feedback is appreciated once your problem is solved!


Sta Rite 333 Btu... | Answered on Apr 17, 2019


bit of a trick and you must use force it will eventually come out of the ring. new one seems to go in in easier tho

Sta Rite... | Answered on Jul 28, 2018


Request the diagram from Sta Rite.

Sta Rite Pool &... | Answered on Jul 20, 2018


3.5 to 4K If you want to bypass the sensor just jump a 1 dollar resistor in between the two wires. If you want to put another sensor just use a standard gas heater flute sensor(2dollars) and put in line with the resistor

Sta Rite... | Answered on Apr 18, 2018


see if heater in remote tstat you can only control with controller if needed put in manual then you have to change from pool to spa

Sta Rite Sr333lp... | Answered on Feb 09, 2018


means unit tried to fire 3 times then locked out turn off then turn back on check ignitor

Sta Rite... | Answered on Feb 09, 2018


check to see if ignitor is glowing at start up and gas on

Sta Rite Pool &... | Answered on Jan 20, 2018


check gas and ignitor

Sta Rite Pool &... | Answered on Jan 13, 2018


fire mans switch continuity or 24 volts if 220 hook up make sure wiring correct in heater if wired for 120 volt wrecked high voltage board and fenwal and ignitor and fan motor

Sta Rite 200 Btu... | Answered on Jan 13, 2018


yes to firemans switch or run heater to pool hook up

Sta Rite... | Answered on Jan 13, 2018


if replacement buttons available or clean contacts when off possible board going

Sta Rite... | Answered on Jan 09, 2018


bad ignitor if gas to unit

Sta Rite... | Answered on Dec 05, 2017


if voltage to unit bad motor

Sta Rite Pool &... | Answered on Dec 05, 2017

Not finding what you are looking for?
Sta Rite Logo

859 questions posted

Ask a Question

Usually answered in minutes!

Top Sta Rite Pool & Spa Experts

US Parts Center
US Parts Center

Level 3 Expert

719 Answers

john h

Level 3 Expert

22486 Answers

Mike

Level 3 Expert

4367 Answers

Are you a Sta Rite Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...