Shoprider Health & Beauty - Page 3 - Recent Questions, Troubleshooting & Support
How do I unlock my shoprider streamer
hi, try this
1. While the Dynamic controller is locked, press the on/off key to turn on the controller. All LEDs will flash briefly. The LEDs will then slowly ripple from right to left. 2. Press the horn key twice before the LED ripple has completed, approximately 10 seconds. The controller is now unlocked.
Regards
Rob
Don't have a troubleshooting book. replaced
Hi. Some shoprider machines have fault codes and most dont. I will try and cover what the main faults might be.
Free-wheel lever in the wrong position. Faulty brake coil. Resistance should be about 50 ohm's.
Stuck brush in the motor stopping the motor from operating. Check the resistance through the motor, should be approx. 1 ohm.
Speed lever ( wig wag ) not in central or neutral position or faulty..
Battery voltage too low or battery leads faulty.
Good luck. Neil.
11/16/2018 11:08:44 AM •
Shoprider...
•
Answered
on Nov 16, 2018
Shoprider
`Hi. Sounds very much like a loose battery terminal, or a faulty battery lead connector.
I have also had a few machines that can start jerking because of worn or stuck motor brushes.
Also check the high/low speed switch if you have one, they sometimes cause problems.
How old are your batteries, worn out batteries can still be " fully charged", but are unable to supply the current ( amps ), that the motor needs.
Good luck. Neil.
11/16/2018 11:01:02 AM •
Shoprider...
•
Answered
on Nov 16, 2018
Not finding what you are looking for?