Sea-Doo US Boating - Popular Questions, Answers, Tips & Manuals
My 2007 sea do RXP won't shut off after the key is removed
Hello Lisa,
The most likely fix is for you to check the wires connected to the engine block and verify that they are not broken. There is 1 wire that connects to the engine block then goes to the key, then from the key to the ignition coil block. When the key is in the "on" position the switch is actually open allowing the engine to run. When the switch is in the "off" position it is actually closed and shorting out the ignition block and killing the spark generation, therefore shutting down the engine. So with a broken wire the engine will not shut down at all!!
Rope ***** around shaft
Question, if it is a question not a statement, is way to ambiguous for a decent answer. Much more info needed. The answer to this would be to simply remove the rope.
Po544 fault code
po544 code is exhaust gas temp sensor functional problem ! is this in the water or on the hose pipe as hose water pressure may be low ? you can only run seadoos for 3min out of water on a hose pipe as the engine cooling system will overheat !
Help!! '97 Seadoo GTI, just had the carburetor
Sounds like you might have the rotary valve in the wrong position. Also you are going to need to replace your fuel lines and check the fuel petcock for any blockage. Lastly, when u rebuilt this carb did you check the tiny fuel filter behind the pump body?
9/23/2013 7:42:36 PM •
Sea-Doo US...
•
614 views • 0 helpful votes
Id like to winterize mine don't see spark plugs
No need to remove plugs, really no need to do anything to it but add fuel stabilizer, remove battery, spray engine down with some WD40 and make sure you blow all the water out of the exhaust system.
Not finding what you are looking for?