Sea-Doo US GTX Wake 155 - Recent Questions, Troubleshooting & Support

Water could be getting into the engine from the exhaust system which may not be totally drained. Remove the exhaust pipe, remove the spark plugs and turn it over with the starter. Now drain the oil, replace the plugs and try starting without the exhaust - on land - briefly. Now check the oil again. Water can only be coming from the intake or the exhaust so just keep looking for the source. Mine took quite awhile to clear but now works fine.

Have you tried unhooking the battery and then hooking it back this will reset the computer to default settings for the fuel injection, could fix your problem.

Air vents for the fuel and oil tanks.

Well, you are welcome, but I did nothing to make that happen! I suggest you sell that old piece of junk and get a new machine!

Hello Lisa, The most likely fix is for you to check the wires connected to the engine block and verify that they are not broken. There is 1 wire that connects to the engine block then goes to the key, then from the key to the ignition coil block. When the key is in the "on" position the switch is actually open allowing the engine to run. When the switch is in the "off" position it is actually closed and shorting out the ignition block and killing the spark generation, therefore shutting down the engine. So with a broken wire the engine will not shut down at all!!

have you checked the intercooler isnt leaking water into the air intake while running ?

take it back to dealer ss warranty !!

key faulty , get dealer to recode it or replace it !

Pull the plugs and fill it with wd-40.
And whatever you remove just replace tightly.
Unless its a head gasket or gasket mated part, torque values aren't that critical . Too loose and they'll vibrate out. Too tight and you'll snap or strip it out. A lot of repairs at shops are seldom torqued it all goes by feeling and for the stuff that needs to be torqued like internal parts just google whatever part it is and the type of ski and it'll show in your search.

Question, if it is a question not a statement, is way to ambiguous for a decent answer. Much more info needed. The answer to this would be to simply remove the rope.

carburetta main jet