Roland Music - Page 8 - Recent Questions, Troubleshooting & Support
Boss br-600 unsupported card
I have the exact same problem. All my flash cards worked fine, and all of the sudden, none work. Not even the one that came with it. I am still trying to fine the reason. I bought it eight years ago, that might be it.
I just get a pedalboard.
I
Be careful, while most pedals are consistent with the 9 volt DC polarity, SOME BOSS pedals use AC inout. Those typically will appear to work on the DC inout, but fail to pass audio through the effect. Read instructions for EACH pedal and verify the requirements.
Will amp still work after third prong is broke
If the third prong is the round one, then that is the ground to your amp. It will still work, however, the amplifier will not be properly grounded. So in a pinch you can use it, but you need to get the cable replaced. The ground wire is there for your safety, in case you plug your amp into a mis-wired outlet or if you are plugging in another instrument like a keyboard, mixer etc. that may be mis-wired. This could lead to a bad shock or worse. You have been warned.
No power when switch on with 9 v DC transformer
Is the transformer you are using the original? or are you using one that you picked up. If it is not the original, you have to make sure that the voltage and ground on the plug matches what the unit needs. Some adapters reverse the + and - on the tip and sleeve on the plug.
Not finding what you are looking for?