Roland Music - Page 2 - Recent Questions, Troubleshooting & Support
MY Roland Handsonic's digital display is gone
Hell,
there is no display on your Roland Handsonic because the screen inverter or screen board panel is faulty. This has to be replaced for you to see your digital display again.
So its either you use it like that without the display or you take it to a repairer for fixing.
Take care.
7/11/2022 8:54:01 AM •
Roland Music
•
Answered
on Jul 11, 2022
When I turn on my
Hi. I had the same problem and fixed it by clearing all the phrases. An explanation of how to do this is below (written by someone else, not me) But, expect your guide beat to now sound like a fuzz instead of a drum. This really sucks and there is apparantly no fix for the guide sound except to send it back to Boss. Good luck.
1. Start by selecting Phrase 1.
(if the 'REVERSE' or 'AUTO START' are lit press them off.)
2. Select 'INST & MIC' by pressing 'MODE'
3. Hold down 'EXIT' and 'AUTO START' together - at the same time, this should light up the green LED for 'LOOP PHASE'
4. Hold down 'WRITE' and 'EXIT' together
then hold 'WRITE' on its own
then 'WRITE' and 'EXIT' together again...as if you were clearing a phrase.
they should light up in red and flash, if not try a combo of section 4.
5. Repeat on all Phrases 1 - 11.
My Roland G70 power up problem. .
Open up the Roland G-70 and check if all the connectors and flatcables are well seated. Check also if the power supply is working as supposed to.
1/13/2022 5:29:59 AM •
Roland Music
•
Answered
on Jan 13, 2022
Roland A-90 no sound with sliders on full
i moved you from computers
to music + roland.
it needs service, find a shop to fix it;
IT RAN FOR 1995 TO NOW, 26YEARS
FRANKLY AN AMAZING RUN. FOR SURE.
it needs service, you have 2 choices besides upgrade.
1: shop fix it.
2: buy the service manual and learn electronics.
check DC power rails inside first and fuses .
12/25/2021 1:30:16 PM •
Roland Music
•
Answered
on Dec 25, 2021
No sound on a Roland model KR-4700. All 4 fuses inside are ok.
Do you have an owner's manual......first thing to try would be a factory reset...sometimes this will un-scramble the operating system and set it back to when it left the factory....contact Roland for an owner's manual if you don't have one....hopefully this helps..if not, then you will have to open it up.....
10/18/2021 6:42:25 AM •
Roland Music
•
Answered
on Oct 18, 2021
When i turn on the Fantom G8, it shows a blue
Somehow you have activated the mode to download a new operating system into the unit. It likely is expecting the new SW to be presented form source such as MIDI, USB, or stick.
Get it out of that mode before something gets clobbered. DO a Factory reset which will consists of holding certain buttons and turning power on. Find this procedure in your user manual.
Not finding what you are looking for?