Roland Computers & Internet - Page 2 - Recent Questions, Troubleshooting & Support

change your speaker

check for the power cable or re install the software

This means the low-level part of the operating system is corrupted or missing. Simply try reloading the OS by putting the CD into the CD drive. If it does not allow an OS reload or if it fails, most likely the flash ROM which holds the basic part of the OS has been zapped and will require service. You can also try to replace the internal button battery inside that retains the memory.

Try to initialise (format) it in your computer. Use an external card reader. I think you should use FAT 16 or FAT 32. But once the Roland sees the card, do an initialise there. It could be the Roland can;t work with memory cards above 2 Gbyte, for that try to make a 1 Gbyte partition in your computer and again try if it works.

You need to put jack with matching colour jack .

Try formatting the flash drive. Terry

I found this online....hope it helps... ========================== How do I get computer to recognize printer? You have a problem. Your computer does not recognize the printer. Moreover, you cannot reinstall the printer driver or software because you have misplaced the CD. Well, don't worry. The steps given below will help you out. STEP 1: Checking the Cable and Power Supply The simplest step comes first. Just check whether the printer cable is connected to the computer securely. Moreover, also check whether the printer power cord has been plugged in properly. STEP 2: Uninstall Old Printer Software, If any If you have had an older printer, then make sure that printer drivers and software are uninstalled from the computer. If you don't, the computer might not recognize the new printer. This problem is common in inkjet printers. STEP 3: The Paper Size A simple matter like the incorrect selection of paper might also lead to this problem. If the printer paper size does not match the size set in the printer settings, than the computer might not recognize the printer. STEP 4: Restart There are times when all it requires is to restart the computer. This is in case where you have connected the printer after loading the driver. If this is the case, then just restart your computer. STEP 5: No Pass through Device This is actually an extension of your first step. Make sure that the printer cable has a direct connection to the computer. No pass through devices must be used for this purpose. This Article is written by John C Arkin.

Call the salesman or helpdesk from the brand, your octave assignment ain't right

Try reading the instructions again. I am assuming you have other videos that play.

Please, read the following page: http://www.tervis.fidisk.fi/Roland/Modifications