Remington Health & Beauty - Page 7 - Recent Questions, Troubleshooting & Support

If the shaver heads pops up, this is because you have not cleaned it properly. This is common on this model type. You will need to thoroughly clean the top of the shaver body. Remove the cutters so that you can access it properly. You may need to use a toothpick or similar object to loosen and remove the build-up in the crevices. Then brush it all out with an old toothbrush or similar.
Clean it thoroughly and it will fix your problem


If you require a new screen for your shaver, you will find at shaveroutlet.com. See link below http://shaveroutlet.com/shaver-replacement-parts/remington-sp-390-foil-and-cutter-set.html

Hi there is one on E/BAY cost US $13.90.cheers

see shaveroutlet.com ShaverOutlet com Search results for XF8705

you will find a compatible charger at shaveroutlet.com Remington Charging Adapter fits Most Late Model Remington Shavers

try this link might show you how. How do change rechargeable batteries on Remington 643 shaver Google Search

Batteries require soldering. Compatible battery type can be found at shaveroutlet.com Shaver Replacement Battery AA NiMH

charger for remington MB 4040 Google Search try this link

Remove the batteries and look at the number on them, then go on ebay and you can find a replacement to make up the needed battery cell pack.

On model F5800, the foil removes by firmly grasping on each side and lifting straight up to detach. Once the foil is removed, you can access the blades. They are remove by simply pulling them straight up. Parts for this model can be found at shaveroutlet.com ShaverOutlet com Search results for f5800

Open the device by first taking off the power button. Now you can slide off the plastic part that goes from the power button down to (and around) the charger connector. Remove the screw. Now take a flat screw driver and open the two plastic parts that form the main housing. Remove another two screws that hold the charger connector board. Un-solder the red and black wires that lead to the motor, then you can slide out the charger connector board with the batteries. Replace them by two eneloop (size AA) batteries. Please have a close look: The batteries are soldered both to the board and between each other. Just solder the new batteries in the same way and orientation.

Have you tried looking at a site like eBay or amazon? There is also always the possibility that you might need to get a new shaver if you really can't find the parts you need.

This should help: https://www.youtube.com/watch?v=1iE86OI8CaA