Remington Health & Beauty - Page 3 - Recent Questions, Troubleshooting & Support

under 12 months old , back to the shop for a replacement under warranty out side warranty , junk it as the repair will be more than a new unit

Hi hope this helps...cheers

Model TA-4570 has been discontinued for some time and is no longer available. You can still purchase model TA-3050 as a factory refurbished unit. The only real difference between the TA-4570 and the TA-3050 is that the 4570 is a cord or cordless model whereas the 3050 is a rechargeable model only

You will find model TA-3050 at shaveroutlet.com. See link below

http://shaveroutlet.com/shavers/remington-ta3070-triple-action-shaver-factory-refurbished-p-180.html

Those batteries are usually made specific for that brand and they can be spot welded together and that would make it very hard to get non OEM new ones installed

Not sure about yours but i had one the charger was burnt out so i took the battery out and used it on hydro for several years after that.

http://www.remington-products.com/manuals/ib_mftitaniumu.pdf

In the PDF instructions it describes how to remove the batteries. The instructions fail to mention that there is a spit of yellow glue that is holding one of the batteries to the curcuit board with a death grip. Undoubtedly, you will have to use a knife, not in the glue, but on the skin of the battery. Pull on the teather wire, and slice the battery skin around the glue.

If after removing the batteries, and you are not thouroughly discusted with the manufacturer, then purchase a couple of AA Ni-cad batteries solder the positive of one battery to the negative of the other. then solder the free positive end to the red wire, and then the blue wire to the free negative end. Then try to remember how to reverse the process and put it back together, without leaving any parts out. ;-)

There is a risk of injury by overheating the battery when soldering. That should be avoidable if you remember how to drop solder. Just like its name, it involves having the wire securely held in place. Then hold solder iron over the wire/battery end. Then take some rosin-core solder and apply the solder to the hot tip. Then make sure the newly melted solder lands on the contact. Keep in place until it cools and holds the wire to the battery.

If you think this is better than writing to Remington complaining that they did not make it easier and use contacts, instead of solder, so we can simply pop in a new set of batteries. Or maybe look at other manufacturers, and see if they are any better.

Dorsun eye drop Buy Dorsun T eye drop Online, substitute, price

Eriacta 100mg

Faux Mink Lashes Selfit Lashes Company

Hello, Probably not serious, just needs some lubrication. The shaver is quite a few years old and the grease in the gears and motor shaft has probably dried up. If you disassemble the shaver and lubricate those parts, it should stop the noise

Model MS900 has not been made for several years. If you just bought it, it is old stock and it sounds like the batteries have degraded

contact Remington service people on their web site It is possible that it is a throw away unit