Proscan Recent Questions, Troubleshooting Help & Support

Send the unit to manufacturer for replacement.

Connect a device to it such as a DVD player and the TV s input source.First I would unplug the tv wait about 15 secs and plug it back in

You may care to use another HDMI port to see if it works at all. Change the cords around. If you like using one HDMI source, get an HDMI Switch box from MonoJet.com. For about 10 bucks, the switch box solves a lot of problems.

You got you monies worth out of them and then some, yes replace them if you are able otherwise just start with the one watched most.

You have to change also the input method to En-US

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.