Polaroid Office Equipment & Supplies - Page 9 - Popular Questions, Answers, Tips & Manuals

Try 6000 or 0000

Panasonic support is just about non-existent anymore.

Try here

http://polaroid.com/support.php

The PoGo can connect to a PC with Bluetooth only. Once you establish a Bluetooth connection with your PC, simply copy any JPEG file to the PoGo using Explorer. No printer driver is needed, just copy the file to the PoGo over the Bluetooth connection.
If your PC doesn't have Bluetooth, you can buy a USB Bluetooth dongle for $5-$20.

Hi the passcode should be 6 0 0 0 let me know if you need further assistance.

wa payah kowe boz bali ndeso wae lah

What's 02 lg cookie. Normally cookies have to do with websites.
The technology of the PoGo printer is to send a BlueTooth jpeg file.from your camera/pc to the pogo printer. Nothing to do with website browsers.

6-0-0-0 (according to Polaroid Pogo US manual)

You can clean the print head by using the following procedure from the troubleshooting section of the manual:

Take paper out of the printer
Take a single sheet and put it back in - upside down (i.e. shiny side down).
Close the door and wait for the sheet to eject.
Put all the paper back into the printer in the correct orientation (shiny side up), close the lid and print again.

I've discovered even better results by keeping the special blue sheet that comes with each paper pack. I run the special sheet through before I'm about to use the printer for the first time (after not using it for a few days), and also after every three prints. The result is much better printouts for me. The special blue sheet cleans and calibrates the print head. Just put the blue sheet in the paper tray at the bottom of the stack with the bar code facing down and close the lid. It will automatically eject.

when printing make sure that the paper is inserted in the pogo shiny side up and logo facing down. also try putting through the blue alignment sheet first as the pogo will not work without this. hope this helps

default is 6000

kindly chage the data cable of scanner and port also.

Try entering 1111, 1234, 8888, or 9999.

There isn't any actual HACK type thing that will get you your account back but you can get your Passcode deciphered. There are only a certain number of buttons on the 360 controller that are able to be part of the Passcode. Write all the buttons down on a piece of paper and using and organized manner, find every single possibility and try each one until Voila!! You have deciphered your Passcode! I know this may seem like a long, boring, and tedious process but it is the only way, sorry. Hope my advice helped! =)

first of all make sure that the pogo it turned off insert the paper from the packet with the blue peice on the bottom with the barcode facing down. and the paper facing shiny side up and logo face down. when you turn the pogo on the blue paper will feed through first then the printer is all setup and aligned ready to print via bluetooth or via USB cable. hope this helps

The default passcode for the Pogo is 6000.

Sam

Go to this link and click on User Guide (English):
http://www.polaroid.com/CES/ProductDetail.jsp?folder_id=2534374302037098&prod_code=PG001

connect a usb cable to your camera and then to the pogo.
turn the camera on, the camera will show you a selection of

PC
Printer /// or printbridge
PC Camera

Select Printer

select the picture you want to print,
adjust the settings if needed.
send or print the picture.

the print should begin within 1 minute.

Try 6000?

Install the battery (see above steps).
Connect the AC adapter to the printer and the power source.
Notes:
Before using the printer on battery power, fully charge the battery for
2.5 hours.
You can print photos while plugged into the power source.

Your best bet is to reinstall the software and use a new PIN.