Polaroid POGO - Answered Questions & Fixed Issues - Page 7
Streaks in my pictures
You can clean the print head by using the following procedure from the troubleshooting section of the manual:
Take paper out of the printer
Take a single sheet and put it back in - upside down (i.e. shiny side down).
Close the door and wait for the sheet to eject.
Put all the paper back into the printer in the correct orientation (shiny side up), close the lid and print again.
I've discovered even better results by keeping the special blue sheet that comes with each paper pack. I run the special sheet through before I'm about to use the printer for the first time (after not using it for a few days), and also after every three prints. The result is much better printouts for me. The special blue sheet cleans and calibrates the print head. Just put the blue sheet in the paper tray at the bottom of the stack with the bar code facing down and close the lid. It will automatically eject.
5/15/2009 6:07:50 PM •
Polaroid PoGo...
•
Answered
on May 15, 2009
•
4,900 views
Any way to connect to a PC with Blue Tooth
No printer driver needed. Just establish a Bluetooth connection between the PC and the PoGo, then send the file to the PoGo using Explorer. In Windows you can right click on the JPEG file and send to - bluetooth device.
Battery
Install the battery (see above steps).
Connect the AC adapter to the printer and the power source.
Notes:
Before using the printer on battery power, fully charge the battery for
2.5 hours.
You can print photos while plugged into the power source.
Can you connect a PoGo
I connect to my pogo via bluetooth with my laptop, To print a picture - Right click on the picture file and send to the bluetooth device.
I would love to see a rinter driver for it myself.
1/18/2013 6:42:44 PM •
Polaroid PoGo...
•
Answered
on Jan 18, 2013
•
1,280 views
Hi I am trying to
I have that camera and a new Pogo printer. To print, attach the camera to the printer with a USB cable. Make sure the camera's "take pictures/view pictures" slide switch is in the down view pictures position. Turn on the printer, turn on the camera. Select the picture to print. Press the camera's FUNC SET button. Accept the default settings and press the FUNC SET button again. In a few seconds, your picture should start to print.
Snap. Why won't it turn off?
There is no such external reset buttons to modern TVs. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.
Error message
Hey my camera is having the same problem I was wondering if you ever solved the problem? If you did how?
Not finding what you are looking for?