Philips Irons - Popular Questions, Answers, Tips & Manuals

heres the service manual https://www.manualslib.com/manual/1223810/Philips-Gc6103.html

You should hear the boiler heat up the water. When you pull/push the trigger, a pump should be activated and steam should be released. If the pump is not working, it could be a defective capacitor acording to this article: https://lieven.kks36.be/2016/06/11/philips-perfectcare-aqua-does-not-pump-solved A spare capacitor should cost you no more than a few dollars, just find somebody with electronics/soldering repair skills.

Then replace it because they are not repaired.

Because its a temperature controlled iron, I would say that it only gets to the temperature to create steam and no hotter.

http://www.p4c.philips.com/cgi-bin/dcbint/cpindex.pl?slg=en&scy=tr&ctn=GC2048/80 Kenneth download the PDF version if you can't read it downlaod acrobat reader http://get.adobe.com/uk/reader/

We have the same problem here. The station only switches off after some time, but the iron itself keeps being switched on. So you manually have to switch on the station many times during ironing which is very annoying (for my wife). This was working before and we have tested here on different circuits already.

broken studs for screw tightning,cant repair without expert,there is one screw under main wire side,second is under pressure knobs to open it

internal sealing ,rubber washers destroyed,,by expert professional

You will need to create an account and then register. Try this link: https://secure.philips.co.uk/myphilips/landing.jsp?country=GB&language=en&catalogType=CONSUMER

set thermostat in lowest position first,,then increase it if u feel to increase heat as per ur requirementthe need

Hi, I remember reading a # stamped right on the prongs of the plug in. Let me know if that works!

this is due to low quility of metal which is damaged use some water unreacting metal.

this is due to small pores in iron close them with some sticky or like fevikol

follow this test and fix it. God bless you As with many small appliances, regular maintenance makes a dramatic difference in how trouble free your electric iron will be. Even so, things can happen. If the iron doesn't heat, make sure power is on to the outlet, check the power cord and check the thermostat and replace if necessary. If the iron heats but steams improperly, inspect the soleplate and clean the vents and flush sediment out of the steam chamber If the iron produces too much or too little heat, test the power cord Also test and, if needed, adjust calibration of the thermostat . If the iron does not spray properly, inspect and clean the nozzle If the iron leaks or spits, clean the steam vents, nozzle, and tank. If the iron sticks to fabric, clean or repair the soleplate. If the iron stains fabric, clean the soleplate, clean the tank with a commercial cleaner, and use distilled or filtered water.

u need to descale again use a strong mix this time its not cleaned enough

Hey did you ever get an answer to your question? I have the same problem

If the iron doesn't heat, make sure power is on to the outlet,,test the outlet with desk lamp for to see if working. check the electrical cord, and check the thermostat + fuse inside replace if necessary.God bless you

you have to take it apart and should be inside if it has one irons are usally sensored

Thermistor is probably damaged, and the machine does not identify that the steam is ready (max temperature was reached) and pressing the steam button wont do anything. Change the thermistor (should be carried out by professional technician).

check for a short wiring in the terminal of the filament.make sure the terminal is dry no water leak.