Pentax Photography - Page 8 - Recent Questions, Troubleshooting & Support
How to reassemble 50 mm pentax slr lens
The problem usually comes about when the focussing ring comes loose. Step 1 remove the 1.front round name ring 2. filter ring. this will expose three screws that hole the focus ring in place. reset the focussing to infinity on your viewfinder then set the ring to the infinity mark and retighten. If the helicoid has come apart then take the mount ring out, aperture ring out, and remove the two focus guides. turn the core out, set the fine thread back until it is almost against the ring directly behind it. make sure that it has at least one and one half turns. then engage the helicoid back. refit the focussing core into the lens and refit the two guides.reassemble the lens and revert to step one to reset the lens.
Can you convert a PENTAX K1000 to digital?
In theory, yes. You'd have to strip out the film mechanism, then design, build, and install the electronics. Kodak spent millions of dollars in research and development doing just that to convert some Canon and Nikon film SLRs to digital, then sold those cameras for more than $10,000 dollars apiece.
In practice, it would be much easier and much, much cheaper to just buy a new digital camera.
Some frames on film are partially overlaped
After you remove the bottom cover on these, there is a steel plate. Under the plate is a phase switch which needs to be cleaned. You have to de-solder several flex circuits to get the plate off, and when the plate is removed there is a loose spring (if memory serves me correctly, I haven't done one of these in years).
Also, the black button you push to free the flash has lips on the inside that have a strong spring attached, and the lips break off. They can fall into the gearing on the bottom
The light meter is not working on my Pentax K1000
there are three different possibilities. remove three screws, take off bottom cover. remove three screws of battery holder, lift to see if the battery wire has corroded or broken off. solve by extending wire and resoldering. the next involves removing the top cover to see if the meter coil is dead,if this is the case it needs to be replaced, or there is a broken lead somewhere. usually it is cause no. 1.
Not finding what you are looking for?