Pentair Plumbing - Recent Questions, Troubleshooting & Support
Flotec FP7120-08 replacement
- Check the pressure switch: The pressure switch is designed to turn the pump on and off as needed. If the switch is faulty, it may cause the pump to continuously cycle. Check the pressure switch and replace it if necessary.
- Check the air valve: The air valve is designed to release air from the tank as water pumps into it. If the air valve is malfunctioning, it may cause water to stream out of the valve when pressed. Check the air valve and replace it if necessary.
- Check for leaks: Even if you don't see any visible leaks, there may be a small leak that is causing the pump to cycle continuously. Check all connections and fittings for any signs of leaks and repair as needed.
- Consider a replacement tank: If you are unable to locate a direct replacement for your FP7120-08 tank, you may be able to find a compatible tank from another brand or model. Consult with a plumbing or water pump specialist to determine if there are any options for a drop-in replacement tank that would work with your system.
Note that it is recommended to consult with a professional plumber or water pump specialist to ensure that any repairs or modifications are done safely and correctly.
Not filtering
too many chemicals will cloud contact the company website or did you maybe its the water change the water
Well water pump won't stop running
if it is a submersible well pump it could be crack in your line leading to the bottom of your commercial welcome and called it to leak water and still feel pressured
if it is a submersible well pump it could have a crack in the line leading to the summer double well pump in the ground it will cause it to leak but the tank will still be build up pressure
Pool plumbing diagram
You may experience a little pressure loss, but if the catridge fliter housing has a 1 1/2 input you should be fine.
Pump wiring diagram
I am sorry, but if you don't know enough to know how to wire a 3 phase pump, maybe you shouldn't. You MUST use a starter of the correct size. The pump should either have a wiring diagram on it near the nameplate or inside the wiring cover at the rear of the pump. You really should have an electrician do this as the specific wiring depends on the motor brand that is on the pump. I have installed 3 Pentair pumps, all the same "item #, and they all were wired a little differently.
My whisperflo wfk 3 has a leak from under the pump. How to repair it
you may have a crack in the pot housing, a leaking seal if the water is coming out under the motor( be very careful if so, shock hazard), or the drain plug at the bottom of the pot may be loose or broken. If you can isolate it to the strainer pot, then you may be able to replace just that. A leaking seal is tougher.
What causes a fuse to blow
I would suspect either you have a short somewhere or your circuit breaker may need replacing. Talk to a well company for possibilities.
I have a 6 year old Pentair Dynamo 340210 pump for
It sounds like you have a air leak on the suction side. I am assuming the pump is operating at full speed. Check for a cracked line especially around fittings. Try cycling the back flush valve as well. I hope that helps.
Flotec water pump
The pump may be wearing out or the foot valve is leaking baring no leaks in the plumbing.
Error after short prime cycle
AIR LEAK IN SUCTION LINE. PUT A GARDEN HOSE WITH A RAG AROUND IT TO BACKFEED FROM INTAKE IN POOL. WITH PUMP "OFF" TO LOCATE BREECH IN LINE.
4/22/2014 3:42:42 PM •
Pentair...
•
Answered
on Apr 22, 2014
Not finding what you are looking for?