Panasonic Office Equipment & Supplies - Page 7 - Recent Questions, Troubleshooting & Support
REMOVED PAPER JAM
There should be 2 switch actuators sticking up underneath of the toner cartridge, maybe one got knocked off?
7/31/2018 6:29:38 AM •
Panasonic...
•
Answered
on Jul 31, 2018
"Call Service 3"
if doing menu #9000*550 did not solve the problem for call service 3, it is better to call your panasonic service center.
the problem is in fuser unit. the thermistor maybe dirty or damage. careful to touch the fuser unit for it is really hot.
7/24/2018 8:58:48 AM •
Panasonic...
•
Answered
on Jul 24, 2018
Well I have the pansonic DP8016 <It shows
It means the fuser section (the Hot Part) has g,one bad to clear the code you will need to get into the tech mode. "Function", "3", Orignal Size "Legal" that order once there go to F9 Look for Fuser Reset then turn off the machine wait 10 seconds turn on if it comes back the fuser needs replacing or worse thre main board! Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
Panasonic ft983 check stacker and jam paper error plz solve this problm
you need too take the back off and clean all !! the rollers
i use white vinegar acetic acid
you can also buy rubber roller rejuvenator liquid
its quite expensive and tbh isnt much better than vinegar
sounds like the stacker has an issue
carefully check around the whole unit for any bits of paper
thats got jammed and is slowing down rollers etc etc
How to clear call for p/m fuser web on a panasonic dp 8035
"Call for P/M Fuser Web" (Default: 240K)1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.2. Press the "Function", "Original Size (Ledger/A3)", and "3" keys simultaneously to enter the ServiceMode.3. Enter the password, and select "OK" button (default password is 00000000).4. Enter the Copy Service Mode F5-73 (Fuser web) PM cycle and change to the desired value.5. Press "Function" and "C (CLEAR)" keys simultaneously to exit the Service Mode.
5/30/2018 7:51:09 PM •
Panasonic...
•
Answered
on May 30, 2018
Not finding what you are looking for?