Ovens - Popular Questions, Answers, Tips & Manuals

Garland Ranges are not suitable for home use! They are restaurant, catering and cafe quality in an environment where children are not permitted. You can put a physical barrier in front of it, but in my day, parents said "don't go near this or you will get burned", and if you did, it was a learning process. Take them close to it and let them feel the heat. Have a safety discussion with them. See, all are stated for 'Catering'. I am a retired chef and hospitality manager, this is my trade and my career, I am also a safety trainer. https://www.google.com/search?q=Garland+gas+ovens ..

https://www.google.com/search?q=KitchenAid+Double+Oven+Model+KEBS209BSS.+The+panel+reads+remove+probe+or+set+probe+temp

This is a virtually unknown make. The link might be better where you live. https://www.google.com/search?q=shacklock+S660+oven Tag the word 'manual' to the link if you get hits and press enter. ..

xfbxbxb

Try the Key Unlock procedure. It is worth a try. Page 7. https://www.rangemaster.co.uk/sites/default/files/user_guides_uploaded/U110602-05d%20%5BGB%5D.pdf ..

This error usually means that the cooling fan, WP74008383, is bad or can't rotate due to build up on the fan. The fan is part 20 on the control panel and internal controls diagram here: https://www.searspartsdirect.com/model/39577ix2rq-001266/jenn-air-jjw9630ddb-electric-wall-oven-parts . The direct link to the part from this supplier is https://www.searspartsdirect.com/product/63d8xvl5zg-0022-464/id-74008383 . This fan is accessed from the back of the wall oven. Thus you have to cut the power to the oven and remove it from the wall. This may be a job for a repair technician. I hope this helps. Cindy Wells

Caroline most likely oven got too hot Is it a Fisher and Paykel electric oven ? If it stays on the oven after it cools down remove the power to the oven may have to flick off circuit breaker or pull the fuse to oven electrical circuit. Wait 30 seconds and flick on circuit breaker or put fuse back .

Try a power reset:

Reset power to the product:
Power unit down by turning off the circuit breaker(s) or fuse(s) for one (1) minute.
Power unit up by turning on the circuit breaker(s) or fuse(s).
Monitor the oven for one (1) minute to ensure the error code does not display again.
Verify oven operation.

Is there an error code?

Unlikely there would be no air spilling through the door seal because it is an oven and not a watertight compartment. An oven door seal needs to be hard wearing and able to withstand high temperatures and hot grease which limits the materials used, that and the fact few domestic oven doors actually latch these days but are held closed by springs meaning the pressure against the seal is relatively light which means the door, the shut and the seal must be manufactured to a high degree of accuracy and properly adjusted. If the amount or air leakage is excessive perhaps the door could be adjusted or the seal replaced. Try asking around to find someone with a similar oven so you can compare...

Check your fuses, make sure the oven is not in timer mode.

The light may just be a burned out light bulb. Remove it and take it to an appliance store to find a replacement. As far as the oven goes, elements do burn out. They are relatively inexpensive. Make sure you have turned the oven OFF before you do anything. The heating elements do pull out and you can replace them yourself. Take the information about your oven and the heating element to an appliance store for a direct replacement.

on your browser search bar type in---bench top ovens -- and pages will come up go to e-bay in the search bar type--bench top ovens and see what you get

You turn it on, it heats up the box and cooks your food inside. No info on what oven doesn't help!

you shud go ovre some one you knows home

It sounds like the fuse for the elements has blown. The oven itself is getting power because the light in the oven comes on. I assume the clock or digital readout is still working? Then it is most likely the main fuse for the elements. If you tell me the make and model number of the stove I can look up the service manual and give you specific directions to check the fuse. This will confirm that this is in fact the issue and also get you the fuse so you may purchase the correct replacement. Its easier to buy when you have the old one in your hand when you walk it the parts store or are looking for it online.

Without make & model I would suggest probably not but you could search online for replacement display.

What brand oven, manufacturer, model no.?

The control panel has failed.

Tom Sh, you own every kind of appliance, or you are attempting to be a repairman with free advice from Fixya? Replace the touchpad. Help Me Find My Model Number RepairClinic com

Hi Amanda, you don't say where you are? Maybe worth contacting these people with the Oven model number.