Ram problems...msi k8n neo4 platinum
You will need to manually set the ram speed, in the BIOS to 333MHz as the board does not support 400MHz in dual channel mode. Also, the slot lay out is every other slot, so you need to put one brand of RAM in slots one and three, then the other brand in slots 2 and 4. The 3GB maybe incomparability in using two different brands. I had this exact board and it was very finicky with RAM. I know DDR is expensive, so you may be stuck with 3GB, but I'd expect some errors. You see, each brand may have different timings the old BIOS cannot pair up between the brands, causing a conflict and causing you to lose out on 1GB of RAM.
Check the manual pages 2-7 and 2-8 for memory configurations.you can get the manual from here: https://us.msi.com/Motherboard/support/K8N_Neo4_Platinum_PCB_1.0#down-manual
I got the msi gt 610 1gb and its beeping causing
Find the voltage setting from MSI then enter your UEFI BIOS. switch to Advance find the Video card section and update it to your manfuctures settings. this is not Over clocking it is a simple adjustment. hare are the recommended speeds for your card.
810 MHz Core
1024MB DDR3 1334 MHz / 1200 MHz / 1000 MHz Memory
adjust to voltage to lower or raise the MHz
Al iniciar o reiniciar con
The first thing would be to uninstall the Wireless device and software. I would then look for a BIOS update for the mother board it may not be set up to work with a USB wireless device as it is an older model. You may have better luck using a PCI wireless card directly on the Motherboard.
Translated:
Lo primero ser?a desinstalar el dispositivo y el software inal?mbricos. Luego buscar?a una actualizaci?n de la BIOS para la placa madre que podr?a no estar configurada para funcionar con un dispositivo inal?mbrico USB ya que es un modelo anterior. Puede tener mejor suerte usando una tarjeta inal?mbrica PCI directamente en la placa base.
Bisoncam pro not working
Some times an application will turn on your camera. Was there software that came with it? Skype will turn on the Camera.
My MSI U100 Netbook won't charge. I purchased
Yes the AC Cord does go bad , you can also look at the power jack at the back of the Laptop to see if it is loose when you plug it in. I always start with the plug they are usually cheaper than a battery.
11/2/2017 10:43:33 AM •
MSI Wind...
•
Answered
on Nov 02, 2017
Mother board
I reviewed the spec of your mother board and only thing i would look at is see if there is a BIOS update you can install. this would most likely fix it.
Translated:
Revis? las especificaciones de la placa madre y lo ?nico que ver?a es ver si hay una actualizaci?n de la BIOS que pueda instalar. esto lo m?s probable es que lo arregle.
11/2/2017 10:40:12 AM •
MSI P35...
•
Answered
on Nov 02, 2017
Msi laptop
Pull out the hard drive and see if it boots, then plug the hard drive in with the machine on. Follow any messages that appear.
10/15/2017 10:40:55 PM •
MSI M670...
•
Answered
on Oct 15, 2017
MS-7297 Ver 2.1 Not booting: system fan not
you need the right heat sink for the cpu that you are using for the board check on board for cpu plug in, then plug the fan in make sure that you have enought heatsink paste on cpu not to much just enought to do the job. if that dose not do it then the board is bad.
Not finding what you are looking for?