Morphy Richards Microwave Ovens - Popular Questions, Answers, Tips & Manuals
FUSE AND WALL SOCKET OK BUT MICROWAVE WILL NOT SWITCH ON
Quite often there are several outlets on a GFI outlet. It does not have to be the one you are plugged into. Find the GFI outlet in the area where you have it plugged into and reset that. If it won't reset then you have a bad GFI outlet.
Changing ligt bulbin morphy richards 23L
Probably not that hard but you do have to take the cover off and do not go near the heating element as it is charged with electricity. Of course unplug before you do anything.
DOESNT HEAT UP
If the oven light and carousel lights up when you try to heat water in the oven, then your best bet is the fuse for the microwave oven is open. Unplug the oven, open the case after 30 minutes. Be careful of the capacitors. You will see something like a small plastic casing along one of the wires, usually color white. This can be opened. Usually a spare fuse is alongside, remove the fuse and replace it with exactly the same kind and rating. This fuse is not ordinary. It is about 1/8 inch diameter by 2inches approximately. Be careful that you get exactly the same rating of fuse. When you are done, place the plastic fuse case cover secure in place. Then put back the cover. Be careful that you replace the cover very well back. Be sure that you did not detach the door when you are removing the cover. If you have detached the door, you have a serious problem. Your oven might leak and you will have radiation burns. Place a cup of water inside the oven to test it and run the oven for 30 seconds.
Buzzing noise
follow this instruction and fix it. God bless you
- MagnetronIf your
microwave is emanating high pitched or growling noises during operation,
the magnetron could be going bad. Normally a nearly silent part, the
magnetron uses high voltage and induces the frequency required to cook
food. Although normally not a safety hazard to operate, this is a sign
that the magnetron is failing and will need to be replaced as soon as
possible.
- Exhaust fan motorIf
your microwave is making a very loud humming noise during operation, it
could possibly be the exhaust fan motor. If defective the part will need
to be replaced to silence the appliance once more.
- Stirrer motorAnother
leading cause of a noisy microwave is an expired stirrer motor. With use
this part becomes worn and makes a loud grinding noise, which is
usually a leading indicator that the part needs to be replaced. The
stirrer is a metal blade that is slowly turned by the motor. This action
disperses the microwave energy in a random pattern, which heats the
food evenly. If the stirrer motor is determined to be nearing
expiration, it should be replaced to halt the grinding noise.
- Turntable motorA very
common cause for a noisy microwave is a worn out turntable motor. This
is a relatively easy repair and will put an end to the noise once
replaced.
Read more: http://www.appliancepartspros.com/repair-help/microwave-repair-help.html#13#ixzz2ZYUSVYSH
http://www.appliancepartspros.com
Ive got a d90d25eslr111-b1 micro combi,i poached an egg ani ie exploded in the micro,it blew the electic and went off,if i swith it on its ok,as soon as i shut the door it fuses the electric. why plea
see this causes and fix it. God bless youIf the microwave runs for a few seconds and stops the thermostat might be defective. Watch our video on testing thermostats.
If the microwave runs for a few seconds and stops the thermoprotector
may have tripped. This is a safety device to prevent the microwave from
overheating. It can be tested for continuity to see if it's blown.
If the microwave runs for a few seconds and stops the high voltage
transformer might have an intermittent short. This is not common. Check
other components related to the microwave symptom first.
If the microwave runs for a few seconds and stops the touchpad might be
at fault. This is not common. Generally speaking, if the dishwasher
display is working and some of the buttons respond correctly but some
don't, the problem is with the touchpad.
If the microwave runs for a few seconds and stops the touchpad and
control panel might be defective. There are several other components
that can cause this problem, be sure to check any other components
before replacing this board.
If the microwave runs for a few seconds and stops there may be a short
circuit in the main control board. Check other components first, these
boards are often misdiagnosed.
If the microwave runs for a few seconds and then shuts off, a door
switch might have failed intermittently. Check each of the door switches
for any signs of overheating, arcing, or burning. Also check each of
them for continuity. Replace any of the switches that is visibly damaged
or that only has continuity intermittently.
No manual for ag820akf
Take the unit back to the place of purchase for exchange, unless they are willing to give you a manual.
Inside of microwave top peeling and blistering
If it's paint peeling, then once that paint is gone, rust will set in, which can cause arcing and disintegration of the chassis, when ruins the oven.This peeling is usually the result of excess moisture accumulating in the oven due to blocked air vents or poor fan circulation.Once those two issues have been ruled out or dealt with, then always be sure to dry out or leave the microwave open after use.The peeling paint will need to be removed, then the area should be sanded.Then you can apply some
high-temperature appliance paint, available from places like Wal-Mart,
Lowe's or Builder's Square.
We're
happy to help you with free
advice and we'd appreciate your thoughtful rating of our answer.
My problem is i have lost my manual book
Sorry for the delay Margaret, but no instruction manuals for that model are available anywhere online.You are welcome to request a refund of your FixYa service fee, or I can try to help you with any other technical problems you may be having at no additional cost.My aologies once again, and thank you very much for your consideration. I truly hope that we can provide you with better assistance next time.Take care.Joe.
Not finding what you are looking for?