Miele Dishwashers - Page 6 - Recent Questions, Troubleshooting & Support

I have a Miele Futura from about 2011. In 2019, I had the issue were all three yellow lights, cleaning, drying, and end, were flashing, initially after a cycle was running and later, after several resets, almost immediately after trying begin a cycle. I strongly suggest watching Scott the Fix It Guy on YouTube. He shows that there are basically 3 different reasons why. 1. A leak that is tripping the leak sensor. Put the dishwasher on buckets and watch for a leak without the drip pan. If no leak, check the motor. He shows how to remove and inspect. If there is something in the impeller it will trip those three flashing lights. I did that and found no blockages and that too didn't fix it. The final source is the heater / pressure switch. So I ordered that from Miele ($75) replaced it and now it runs great!!

I have a star sapphire Thermador dishwasher that has similar adjustments and if you search your model of Miele and follow that with "inside view" you will probably find a view where you can tell how they're supposed to be placed. It worked for me.

Miele dishwasher G7856 with a F09 or F08 fault , I fixed by unblocking the cold and hot water inlet hoses and filters and valves

Could be soap buildup in the dispenser or on the door hinges. Try running leaving the dispenser door open and run a wash only cycle. It may wash out any soap buildup.

Check the inlet hose to make sure the gauze is not blocked.

pull out filter from bottom of dish washer it is most likely full of stuff and needs a clean out had this happen on a dish washer and it was more serious as it was a faulty main board . Lemon ! had to convince dishwasher company that authorised repairer could not fix it under warranty and get it replaced

Is it level ? Sometimes dishwashers need to be tilted back ever so slightly. This can be done with the front adjustable feet.

Check door mechanism and try unplugging it for few second for resetting internal, call washer factory service dept..

The water in the pan is what is causing the issue - need to find the cause of the leak - door seal or pin hole in a hose - possibly a leaking pump

Perhaps you mean the hinge tension? - take off the toekick at the bottom of the machine and you will see two screws on either side - one is to raise the rear foot and the other to adjust the spring tension for the door

F70 means there is water n the drain pan under the under - ussually indicating a leak somewhere in the system - could be a faulty seal at the door or a hose inside that has a pin hole leak

Model Number please

The part number given is not a Miele part number - most likely that is the issue

Faulty WPS - water intake valve need to be changed

Keep pressing the delay button until it reaches 00:00 - you have to go all the way around

The Level switch is faulty - the purpose is to measure the pressure from the recirc pump - if pressure is insufficient it shuts down the unit. We find that soap deposits are the common cause of the switch failure

If no water is entering the unit then the WPS has failed - this is basically the water intake valve that allows the water to enter the unit