Lexmark JetPrinter - Popular Questions, Answers, Tips & Manuals

I would suspect that there is something along the track that's blocking the printhead carrier from moving left. Do a visual inspection of the entire track area. Try ((very carefully - do not force)) moving the carrier by hand and check for a blockage. If you don't find anything, try unplugging for a few minutes and then try again (powerline glitch?).

You need to buy OEM cartridges, refills will not work due to the printed circuit.

Setting up a Lexmark Z2420 on a wireless connection is a straightforward process, but it can vary depending on your specific network configuration. Here are the general steps you can follow to set up your Lexmark Z2420 on a wireless connection:

1. Connect the printer to the wireless network: Turn on the printer and make sure it is in range of your wireless network. Press the Wireless button on the printer's control panel to access the wireless menu. Use the navigation buttons to select "Wireless Setup Wizard" and then press OK. Follow the on-screen instructions to connect the printer to your wireless network.
2. Install the printer software: Insert the installation CD that came with your printer into your computer's CD drive and follow the on-screen instructions to install the printer software. If you don't have the installation CD, you can download the software from the Lexmark website.
3. Add the printer to your computer: Once the software is installed, add the printer to your computer by following the on-screen instructions. You may be prompted to enter your wireless network name and password.
4. Test the printer: Once the printer is connected to your wireless network, test it by printing a test page from your computer.

It's important to note that the steps may vary depending on your specific network configuration, and it's best to consult the manual or the Lexmark website for the specific instructions. Also, it's important to make sure that your computer and the printer are connected to the same wireless network and that the network is working properly before attempting to connect the printer. If you're still having trouble setting up the printer, you may need to consult the manual or contact Lexmark customer support for additional assistance. if i help my cashapp $ralphpapi

You can try to clean it by using a blower maybe there are some debris stuck on the paper feeder assembly. But if its evident that the rubber of the paper feeder is worn out already then probably needs a replacement. but this parts are sold as one assembly it might cost you a lot.

Not enough info

The only reason it would not work is if the printer is not supported by the operating system or the printer requires a parallel cable and the computer does not have that type of connection. There are parallel to USB adapters but they don't work that well.

You can add the printer by installing the printer driver. Then you will have both printers to choose from when you print.

try working the paper on a flat surface fifty at a time or less, and flip through it with thumb, then hold on either end and straighten, do this several times to airate the paper it gets packed together, this is what we do at print shops. good luck

switch off the printer then u delate noe all

http://support.lexmark.com/index

attempt cleaning with alchol swab on the cartridges then clean mode and try and print test page

Replace pick up rollers If you ordera maintence kit for your model the complete instructions are availabe. It will easy complexity